READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:8605
A0300 | Page 1of | 12 |
POINT POWER JACK FOR 8600 LYTEJACK FIXTURES
NOTE: ACCESS ABOVE CEILING OR BEHIND WALL REQUIRED DURING INSTALLATION.
IF THE CEILING OR WALL IS MADE FROM A DENSE MATERIAL SUCH AS 1/2” PLYWOOD OR 3/4” PLASTERBOARD AND IS FIRMLY ATTACHED TO SUBSTANTIAL STRUCTURE THEN THE POINT POWER JACK CAN BE MOUNTED DIRECTLY TO THE CEILING OR WALL AS SHOWN BELOW.
(* IF THE CEILING OR WALL DOES NOT MEET THESE REQUIREMENTS, USE
NOTE: THE MAXIMUM WATTAGE LABEL SELECTED FOR THIS POWER JACK MUST CORRESPOND TO THE MARKINGS ON THE TRANSFORMER LABEL.
1.Peel the appropriate MAXIMUM WATTAGE LABEL from its backing and adhere it to the gap in the LABEL on the FLANGE of the POINT POWER JACK (Fig. 1).
2.Select the CAP with the same MAXIMUM WATTAGE marking and snap it over the FLANGE (Fig. 2).
NOTE: Use the 35W MAXIMUM WATTAGE LABEL and CAP for fixtures that have
POINT |
|
POWER | LEADS (2) |
JACK |
SPRING TAB
FLANGE
GAP
LABEL ON BOTTOM
OF FLANGE
|
|
| MAXIMUM WATTAGE LABELS | |
|
| FIG. 1 | ||
|
| ATTACH AT INSTALLATION | ||
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ATTACH AT INSTALLATION
CAPS
FIG. 2
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720 | 2000 |