Lightolier instruction sheet IS8629, Instructions for Installation of Lytedrop Fixture

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

“hisfixture is intended for installation in accordance with the National Electrical Code and local

emulations. To assure full compliance with local codes and regulations, check with your local electrical mpector before installation. To prevent electrical shock, turnoff electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

●

INSTRUCTION SHEET NO,

IS:8629

R0992 Page 1 of 2

INSTRUCTIONS FOR INSTALLATION OF LYTEDROP FIXTURE

FOR USE WITH 8600 SERl~S POWER JACKS ONLY

SETTING THE HEIGHT

POWER JACK ENTRY

1.Determine the distance “A” between the SOCKET HOLDER and the POWER JACK ENTRY.

ELECTRICAL CONNECTIONS (FIG. 2 &3)

1.Thread the ELECTRICAL CORD through the WIRING CHAMBER (Fig. 2).

2.Knot the ELECTRICAL CORD so a length of (“A” minus 1 1/4”) remains from the knot to

the socket holder (Fig. 2). STEM BUSHING

3.Cut the electrical cord 2“ from knot (Fig. 2).

4.Trim the outer jacket back 1 1/2” from the end of the CORD. DO NOT CUT WIRE (Fig. 2).

5. Strip 3/8” of the insulation on the wires from the JACK ASSEMBLY and ELECTRICAL	.~
CORD. Join them with the WIRE NUTS provided (no polarity needed) (Fig. 2).

6.Position the WIRE NUTS as shown in Fig. 3 and insert them into the WIRING CHAMBER along with the base of the JACK ASSEMBLY.

7.Lineup the 2 holes in the base of the JACK ASSEMBLY with the 2 holes in the WIRING CHAMBER and screw in the 2 SCREWS (Figs. 2).

	ELECTRICAL CORD
..	SOCKET HOLDER

FIG. 1

WIRE NUT

SOCKET

			SCREW		HOLDER
I!!		+=	r	ELECTRICAL COR
--::~-
		‘
1
		-----	—-----	--	2
		---	---—-	---
-ti-;jl~~	~	3
	“	WIRINGCHAMBE
		R3	“A”MINUS1 1/4

FIG. 2

1-B c> 1“1 T<> LIE la ER’AHN!WR%IU’::