READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:C4CEX
A0604 |
| Page 1 of 2 |
INSTALLATION PROCEDURE FOR: C4CEX (EXPO) SERIES H.I.D. SURFACE CYLINDER
STEP 1: Screw OUTLET BOX SCREWS (not provided) to 4” octagon outlet box, leaving about ¼” space for engaging the
MOUNTING PLATE.
STEP 2: Pass supply wires into large
STEP 3: Position key slots in MOUNTING PLATE onto the heads of OUTLET BOX SCREWS; shift housing into place and secure by tightening the screws firmly.
STEP 4: Make Connections. Bare Copper and/or green insulation wire(s) must be connected to SUPPLY GROUND. Connect WHITE BALLAST LEAD to NUETRAL (WHITE) SUPPLY LEAD. Connect BLACK BALLAST LEAD to HOT SUPPLY LEAD. Use wire nuts (local hardware items). Place wire nuts into outlet box.
STEP 5: Install BALLAST SUPPORT onto MOUNTING PLATE, secure with threaded CAP NUTS (DO NOT OVER TORQUE),
STEP 6: Install lamp. (Use only T4.5 metal halide lamp with G8.5 base).
STEP 7: Install LAMP BARRIER into the INNER GLASS assembly and secure with RETAINING SPRING.
STEP 8: Attach the INNER GLASS assembly to the REFLECTOR by lining up the pins on the REFLECTOR and the slots on the INNER GLASS assembly and turn clockwise until tight.
STEP 9: Install OUTER GLASS by positioning over the INNER BALLAST ASSEMBLY and secure with three set screws
STEP 10: Position REFLECTOR HOUSING onto center stud, secure it with LOCK.
STEP 11: Slide the UPPER HOUSING over the OUTER GLASS and attach to the INNER BALLAST ASSEMBLY. Secure by twisting the housing clockwise until tight.
CAUTION: DO NOT ENERGIZE
THE LAMP UNTIL THE FIXTURE
IS COMPLETELY ASSEMBLED
AND INSTALLED.
OUTLET BOX
SCREWS
MOUNTING PLATE
BALLAST
SUPPORT
CAP NUTS
INNER BALLAST
ASSEMBLY
REFLECTOR
RETAINING SPRING
LAMP BARRIER
INNER GLASS
OUTER GLASS
UPPER HOUSING
A 
COMPANY