IS C4P20MH, Instruction Sheet No

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

IS:C4P20MH

B0904

Page 1 of 2

INSTALLATION INSTRUCTIONS FOR 4", 6", AND 7" RECESSED

CAUTION: (RISK OF FIRE) DO NOT INSTALL INSULATION ABOVE NOR WITHIN 3 INCHES (76mm) OF ANY

PART OF THE LUMINAIRE (LIGHTING FIXTURE)

CAUTION: USE ONLY ROUGH-IN SECTIONS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’ ROUGH-IN KITS

WILL VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

				CONE
	PAR-type Open	ED17 Horizontal Lamp
	Downlights,	ED17 Horizontal Lamp
	Downlights,	1-piece Construction		PAR-type Open
	1-Piece Construction	1-piece Construction		PAR-type Open
				Downlights,
				2-Piece Construction
			TRIM
	LAMPHOLDER		RETENTION
	(supplied with frame)		SPRING
	LAMPHOLDER
	SPRING
	(supplied with frame)
	REFLECTOR NECK
	Fig. 1
			Fig. 2
Installing Lampholder onto Reflector (Fig. 1)
1.	Bring LAMPHOLDER through frame opening into workspace.
2.	Snap LAMPHOLDER SPRING into two slots on REFLECTOR NECK.
3.	Check to make sure that both sides of LAMPHOLDER SPRING are fully engaged into slots.
4. Reflector trim is now ready for installation into ceiling.

Installing Reflector into Frame (Fig. 2)

1.Install LAMPHOLDER onto REFLECTOR NECK.

2.Feed assembled REFLECTOR into frame opening by aligning as shown, and pushing up on FLANGE until it is fully installed into frame opening.

Re-lamping

1.To re-lamp one-piece units, simply unscrew the old lamp and replace with a new one. There is no need to remove trim from ceiling.

2.For two-piece constructions, remove CONE by pulling out of trim assembly, re-lamp, and then replace CONE.

3.See trim labeling for correct lamp info. Follow lamp manufacturer's directions for proper care and handling of lamp.