Lightolier IS:1000LV Lamping Fig. H, Transformer Replacement 1000LV, 1000LVE1 and 1000LVE2

INSTALLATION PROCEDURE FOR: LYTECASTER®

1000LV, 1000LVE1 & 1000LVE2 LOW VOLTAGE FRAME-IN

KITS (CONTINUED)

LAMPING (Fig. H)

NOTE: Socket manufacturers have suggested that socket may fail after 3 to 6 relampings. If this occurs, socket can be replaced by disconnecting male connectors (attached to socket leads) from female connectors (attached to fixture leads) and replacing it with a new socket procured through LIGHTOLIER (Fig. H)

1.Make sure that power is OFF when lamping or relamping. Remove LAMP RING from SOCKET CUP by pulling straight down.

2.Insert LAMP (MR-16) between LAMP SPRINGS until face of lamp sits firmly on GLASS LAMP GUARD

(Fig. I.)

3.Attach SOCKET to bi-pin prongs on LAMP.

4.Insert LAMP RING with LAMP and GLASS LAMP GUARD back into SOCKET CUP.

NOTE: 1. LOW VOLTAGE FIXTURES should be dimmed only with special dimmers intended specifically for that purpose. Use Lightolier Lytemode, Scenist, Crescendo VA, Neptune VA, Precision VA, Easyset VA, Sunrise VA, Radiant VA or equivalent products by others or variable autotransformers or electronic dimmers intended for use with low voltage fixtures. 2. Low voltage fixtures may produce audible sound when used with dimmers, which may be objectional in acoustically critical areas.

TRANSFORMER REPLACEMENT (1000LV, 1000LVE1 and 1000LVE2)

1.Make sure power is off.

2.Remove REFLECTOR TRIM from ceiling.

3.Rotate ROTO CLIPS out of hole area.

4.Remove J-BOX COVER nearest ceiling opening by lifting SPRING.

5.Unsplice all wiring.

6.Remove TRANSFORMER ASSEMBLY from J-BOX by pulling SPRING upward. (Fig. K).

7.Place TRANSFORMER ASSEMBLY thru ceiling opening.

8.Remove TRANSFORMER and TRANSFORMER COVER by straightening TABS with pliers and removing SCREWS. For 1000LVE1 and 1000LVE2, remove TRANSFORMER by removing NUTS.

9.Install the new TRANSFORMER on the U-shaped holder with SCREWS and re-tab to the remaining half of the TRANSFORMER ASSEMBLY. For 1000LVE1 and 1000LVE2, install the new TRANSFORMER, securing with NUTS.

10.Reassemble TRANSFORMER ASSEMBLY to J-BOX by placing J-BOX COVER TABS into J-BOX SLOTS and snapping onto SPRING (Fig. K).

11.Rewire Fixture:

A.Splice transformer red leads to white socket leads.

B.Splice transformer black lead to thermal protector blue lead.

C.Splice transformer and thermal protector white leads to supply common lead.

D.Splice thermal protector black lead to supply black lead.

12.Replace J-BOX COVER.

13.Install REFLECTOR TRIM.

INSTRUCTION SHEET NO.

IS:1000LV

B0607 Page 2 of 2

A COMPANY

631 Airport Road, Fall River, MA 02720