READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1102P1
A0403 | Page 1 of 2 |
INSTALLATION PROCEDURE FOR FRAME-IN KIT 1102P1
(MAY BE USED FOR EITHER 7•11 OR LYTECASTER TRIM)
NEW CONSTRUCTION
FIG. A | FIG. B | FIG. C | FIG. D |
1. | 2. | 3. | 4. |
COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.
1.
Fasten MOUNTING FRAME to wood joist.
NOTE:
1.ADJUSTABLE MOUNTING BARS are
2.MOUNTING BARS can be extended to 24”. The MOUNTING FRAME can be mounted
3.For suspended ceilings, make certain that bottom of MOUNTING FRAME is no higher than 1” above ceiling line and notched area of ADJUSTABLE MOUNTING BARS are positioned on top of
2.
Install plasterboard or other dry type ceiling. Hole in board can be cut either on floor or after the board is secured in the ceiling. Use MOUNT- ING FRAME opening as cutting guide (make sure ROTO CLIPS are rotated out of hole area). ROTO CLIPS can only be rotated
NOTE: For wet plaster ceiling, use Plaster Ring Accessory (order sepa-
rately): No. 1960 for 1002P1
3. | SEE SEPARATE REFLECTOR TRIM | |
4. | INSTRUCTION SHEETS. |
U.S. PATENT NO. 4,039,822
OTHER U.S. AND FOREIGN PATENTS PENDING.
®LIGHTOLIER a GENLYTE THOMAS company. 631 Airport Road, Fall River, MA 02720