READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1102T
E0403 | Page 1 of 2 |
Instructions for Compact Fluorescent
WARNING – (RISK OF FIRE) Do not install insulation within 3 inches of fixture sides or wiring
compartments, nor above fixture in such a manner as to entrap heat.
FRAME-IN
A. WOOD JOIST/METAL STUD CONSTRUCTION |
1. Position |
repositioned to narrow side of frame if required to |
ADJUSTABLE |
|
MOUNTING e |
|
BARS | LOCKING SCREW |
|
locate fixture opening as desired. Extend mounting |
bars, line up bottom edge of bars with bottom of wood |
joist/metal stud and nail in place. For metal stud (Fig. |
A2), fasten with machine screws through holes in the |
mounting bars. Locking screws are provided to lock |
mounting bars in place once positioned properly (Fig. A). |
2. For multiple fixture installations, use centered slots as |
guides to align adjacent fixture (Fig. A). |
B. SUSPENDED CEILING SYSTEM |
1. Position |
repositioned to narrow side of frame if required to |
locate fixture opening as desired. Extend mounting |
bars, until notched opening fits on top of |
(NOTE: Make certain that the bottom of the mounting |
frame is no higher than 1” above the ceiling line). |
up
LINE UP BOTTOM EDGE WITH BOTTOM OF WOOD JOIST
Fig. A
MOUNTING
FRAME
CENTERING
SLOTS
MOUNTING BAR | MOUNTING BAR |
2. Lock mounting bars by bending tab underneath |
bead (Fig. B1), or by using screws for round |
(Fig. B2). |
WIRE-IN
1.White fixture leads to neutral (white) supply lead. Black fixture leads to hot (black) supply leads.
Bare copper and/or green insulated wire(s) must all be connected to supply ground. Use wirenuts for splices (local hardware item). Place all electrical connections in the
2.For ROMEX or BX cable use
Fig. A1 | Fig. A2 |
| |
ADJUSTABLE |
|
MOUNTING | B1 NOTCHED B2 |
BARS | |
| OPENING |
1” MAX.
CLOSE-IN
1.Install plasterboard or other dry type ceiling.
2.Hole in plasterboard can be cut by using mounting frame opening as a guide (Fig. C) (make sure roto clips are rotated counterclockwise out of the hole area, see Fig. D).
3.For wet plaster ceilings, use plaster Ring Accessory No. 1961 (ordered separately).
*See Page 2 for
Fig. B
Fig. C | Fig. D |
ROTO CLIP
MOUNTING |
FRAME |
CEILING MATERIAL
See Reflector Trim Instruction Sheet for Trim Installation
WARNING – Use only reflector trims provided by Lightolier. Use of other Manufacturers’ reflector trims voids
the Underwriters Laboratories listing and could constitute a fire hazard.