Lightolier IS:1155 instruction sheet SwHG, M4srALumor4 of Eveball mw Voltage Trim, 1s1155 R0487

1s1155

R0487

IN!YCALLATION OF ADJUSTABLE ACCENT LIGHT (LOW VOLTAGE TRIM)

6. Remove lAMPHOLDER RING from within HOUSING		swHG-
by pulling straight down, and disengaging ths LAMP
SPRINGS which	also act se a holding mechanism for
lAMPHOLDER	RING.

7.Select voltage (12v., 25-50 Watt, or 5.5v, 25 Watt) depending on lamp being used? by setting SLIDE SWITCH (Fig. J). Insert screwdriver into slot and slide switch if not already set according to lamp being used (See Fig. K).

8.Install proper wattage PAR36 LAMP into IAMP CONNECTOR, making certain the LAMP is seated all the way into the IAMP CONNECTOR.

9.Insert LAMP into LAMPHOLDER RINGS so that face of LAMP is seated, and extended through hole in the LAMPHOLDER RING, and put the lamp and ring back into the LAMPHOLDER SUPPORT so that the LAMP SPRINGS now support all.

LAMP HOLDER -

SUPPORT

LAMP >

CONNECTOR

w

HOUSING

LAMP=------

LAMP HOLDER ~	ti~.	FIG. J
RING

Q\H “\- \.

\ A . .....’ /“ FIG. K

m4srALumor4 OF EVEBALL (mw VOLTAGE TRIM)

6.Remove APERTURE TRIM from within EYEBALL by pullin straight down, and disengaging from SUPP?)RT SPRINGS (Fig. L).

SLID

7.Select voltage (12v., 25-50 Watt, or 5.5v, 25 Watt) depending on lamp being used! by eetting SLIDE SWITCH (Fig. L). Insert screwdrwer into slot and slide switch if not alreedy set according to lamp being used (See Fig. K).

6.Install proper wattage PAR36 LAMP into LAMP CONNECTOR, meidng certain the LAMP ia seated all the way into the IAMP CONNECTOR (Fig, L).

9.Insert LAMP into LAMP SPRING.

co

10, Insert APERTURE TRIM, and LAMP into EYESALL until groovee on APERTURE TRIM engage into SUPPORT SPRINGS [FiO. L).

NOTE LOW VOLTAGE &i+lJRE6 should be dimmed only with speclel dimmers Mended for that purpose. Use Ughtoller Preolslon LV, Eoeniet,

or Lytemcds, or equlvelerrt products ~others or vsrieble eutc-transformers or eleotrcn c dimmers intended for uee with low voltege flsturss.

NOTE law voltege flstures	may produce sudible
sound when used with externel dimme~ which mey		FIG. L
be objectlonsl In acoustically	critlcsl srea%

WARNING USE ONLY REFLECIOR TRIMS PROVIDED SV LIGHTDLIER INC. USE OF ~HER MANUFACTURERS

REFLECIUR TRIMS VOIDS THE UNDERWRITERS IABOFIA30RIES L16TING AND COULD CONSIWIJTE A FIRE HAZARD.