Lightolier IS:4170 instruction sheet Is, ‘ \wlREHARp, r+rn~””’’m’”x, Fixtures Covered, Sheet

.

			INSTRUCTIONSHEETNO.
FIXTURES COVERED	BY THIS INSTRUCTION	SHEET 4170& 4171	IS:4170
INSTRUCTIONS	FOR ASSEMBLY AND	INSTALLATION
			osa9

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prsvent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

1. Thread MOUNTING STUDS into CROSSBAR.			(-r+rn~””’’m’”x
Attach CROSSBAR to OUTLET BOX with
OUTLET BOX SCREWS.
2. Make connections Black fixture lead or fixture
lead without tracer mark to black supply lead;
white fixture lead or fixture lead with tracer		“0””” “RE~-	-
mark to white supply	lead. Uninsulated wire is
a GROUND WIRE and must be attached to
ground terminal or GROUND WIRE in OUTLET
BOX. Use WIRE NUTS (local hardware item).
Place connections in OUTLET BOX.
3. Place CANOPY SUB-ASSEMBLY over
MOUNTING STUDS and tighten with CAP
SCREWS.
4. Install recommended	lamps.

5. Attach GLASS SHADE by looping WIRE HARPS carefully over MOUNTING HOOKS (Fig, 2).

I

STUD (Fig. 2).

WIRE HARP (2)

GLASS SHADE ~

FIG. 1

\

\

FIG. 2

/0?

LEVELING KNOB

LEVELING STUD

!

MOUNTING HOOK

‘ \wlREHARp

//