Lightolier IS:E610 instruction sheet IS E610, A. Frame-Inand Wire-Infig, Instruction Sheet No

G41O, E61O, F71O	INSTRUCTION SHEET NO.
	IS:E610
INSTALLATION OF PRE-WIRED CALCULITE FRAME-IN-KllS
INSTRUCTION SHE~ FOR ITEMS
	R0291	Page 1 of 2

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these Instructions for maintenance referencw

‘a-.”-:

RETAINING

SPRING

..

R

,l#G	T	ti:EmoR
SECTION
			HOUSING
A. FRAME-IN	B. CLOSE.IN	C. SNAP-IN	b. PUSH-IN
FIG. 1	FIG. 2	FIG. 3	FIG. 4

WARNING+RISK OF FIRE)DO NOT INSTALLinSUlatiOn WITHIN3 INCHESOF FIXTURESIDESOR

WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER SO AS TO ENTRAP HEAT.

A. FRAME-IN AND WIRE-IN (FIG. 1)

1, Install FRAME-IN SECTION using ADJUSTABLE MOUNTING BRACKET (see below). Wire to supply leads. White fixture lead to neutral supply lead. Black fixture lead to hot (120V.) supply lead. Bare fixture wire to supply ground. Use wirenuts (local hardware items). Place all electrical connections in the J-BOX. Attach J-BOX COVER onto J-BOX.

2.Adjust MOUNTING FRAME,

- MOUNTING

a. For Flangeless TrimFRAME

Plaster Ceiling.

FIG. 9 :? ;

s

			– MOUNTING
b. For Overlapping	Trim		FRAME
Plaster or Dry	Ceiling.	FIG. 8	.J

[-3

o

Set MOUNTING FRAME so the

@

Set MOUNTING FRAME so the bottom edge

31,” Max

T

bottom edge is flush with finished ceiling, as shown.

is flush with, no higher than %“above finished ceiling, as shown.

1-1<31-170 1-11= I?” ;V:::::L,N::EV::, E:A:Y:;