Lightolier IS:SL402 instruction sheet Instruction Sheet, ISSL402

INSTRUCTION SHEET	IS:SL402
	12-04/Rev-04

INSTRUCTION FOR INSTALLATION ZYLINDER GLAS

FOR METAL HALIDE PENDANT LUMINAIRE

Read and understand these instructions before installing the luminaire.

CAUTION: Branch circuit conductors must be rated 90°C minimum. To prevent electrical shock turn off electricity and check your local electrical code and regulations. Consult a qualified electrician before installing.

WARNING: - Risk of fire: Transformer contains luminaire thermal protector. Use only replacement transformer obtained from Lightolier CFI.

IMPORTANT:

This 39 lb lighting fixture must not to be supported by a junction box. Provide a 6-in diameter anchor plate with three equal support points around the junction box. (Fig.4)

A. BALLAST HOUSING: FIG.1

1.Remove the ballast housing cover with the allen key provided. (Fig.2)

2.	Unfasten the ballast frim the ballast housing. (Fig.3)		BALLAST	BALLAST
3.	Feed the power supply wires through the central opening of		HOUSING	HOUSING
	the ballast housing. (Fig.4)
4.	Rotate the U-bracketsas necessary, and attach to the ceiling			BALLAST
	with the 3-1/2” long screws (3) provided. (Vig.4)		COVER
5.	Replace the ballast in the ballast housing. (Fig.3)
B. GLASS/PROTECTOR:		ALLEN	FIG.2	FIG.3
		KEY
	Note: Remove the protective film from the reflector.			STEM
1.	Push the wires of the lamp housing through the washers with			PINS
	the frosted side of the glass downward, and with the		BALLAST	WASHERS
	polished side of the reflector dome (if applicable) toward the			REFLECTOR
			HOUSING
	glass, the washers, the exagonal screws and the pins. (Fig.5)			DOME

WIRES GLASS

C. STEM:		U-BRACKETS
1.	Align the fastening stem with the U-bracketson the	SUPPLY
	ballast housing. (Fig.6)
		WIRES
2.	Install the threaded bolts over the U-bracketsinto the	SCREW
	fastening stem with the allen key provided. (Fig.6)	FIG.4
3.	Insert the wires into the holes in the U-brackets.(Fig.6)

WASHERS

WIRES

LAMP

HOUSING

FIG.5

D. WIRE-IN: (Fig.7)

1.Connect the white (neutral) wire to the white wire of the ballast.

2.Connect each blue wire of the ballast to each blue wire of the lamp.

3.Connect the black wire of the ballast to the black wire of the switch.

4.Connect the power supply wire (120V, 277V or 347V) to the black wire (switch).

5.Replace the ballast housing cover. (Fig.2)

BALLAST
HOUSING	U-BRACKETS
	THREADED
ALLEN	BOLTS
KEY
FIL	FASTENING

LAMP

HOUSING FIG.6

FIG.7

E. LAMP:

1.Remove the clear glass (top). (Fig.8)

2.Remove the reflector. (Fig.8)

3.Insert one end of the lamp into the socket and snap in the other end. (Fig.9)

4.Replace the glass, keeping the nylon washers up against the glass. (Fig.8)

Note:

-Put back nylon rings on each side of the protective glass.

-Do not over-tighten the cap nusts as this would cause unwanted tension.

GLASS

REFLECTOR

FIG.8

LAMP

SOCKET	CERAMIC METAL HALIDE
	150W T7
	DOUBLE ENDED

FIG.9