READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:26556MCY
0798 | Page 2 of 2 |
ACCESSORIES (Fig. 3)
1.With SNOOT open accessories can be installed or removed.
2.INSTALLING ACCESSORIES: Push accessory(s) into SNOOT snapping them into ACCESSORY SPRINGS.
NOTE: There must always be (1) accessory or clear glass installed in the SNOOT for safety reasons. This FIXTURE takes (2) accessories maximum with or without CROSSBLADE.
3.REMOVING ACCESSORIES: Push ACCESSORIES out of ACCESSORIES SPRING. Push one ACCESSORY SPRING against SNOOT if accessory is difficult to remove.
CROSSBLADE may be removed. Pull CROSSBLADE out of
SNOOT.
CLOSE SNOOT OVER LAMP (Fig. 3)
1.Rotate SNOOT until SLOT mates with ACCESS KNOB.
2.Tighten ACCESS KNOB to secure SNOOT.
FIXTURE OPERATION (Fig. 4)
Turn LAMP on or off by activating the switch. (Fig. 2)
SETTING HORIZONTAL ROTATION
1.Rotate fixture to desired horizontal position. Fixture provides 360° rotation.
CAUTION: There is a STOP that prevents the FIXTURE from being adjusted more than 360°. Do not force FIXTUREagainst the STOP. Rotate the FIXTURE in the opposite direction to obtain the proper aiming location.
SETTING VERTICAL ROTATION
1.Loosen SIDE KNOB.
2.Turn FIXTURE to desired vertical position. The FIXTURE adjust 90° in the vertical direction.
Do not force past the adjustability limits.
3.Tighten SIDE KNOB.
SETTING LAMP ROTATION
1.Loosen LAMP ADJUSTMENT KNOB a few turns.
2.Drive LAMP ADJUSTMENT KNOB in 180° slot.
3.Tighten LAMP ADJUSTMENT KNOB after LAMP is in desired position.
SETTING ACCESSORY ROTATION
1.Loosen ACCESSORY KNOB a few turns.
2.Rotate SNOOT to desired position. SNOOT rotates 360°.
3.Tighten ACCESSORY KNOB.
SNOOT
Fig. 3
SLOT
HORIZONTAL ROTATION
LAMP ROTATION
180° SLOT
LAMP ADJUSTMENT
KNOB
ACCESSORIES KNOB
Fig. 4
ACCESS KNOB
ACCESSORIES
ACCESSORY SPRING
CROSSBLADE
VERTICAL ROTATION
SIDE KNOB
SNOOT
ACCESSORIES ROTATION