Lightolier LSB-16 manual 1BHF

PG

, Ordering Information, Features, Electrical, Mountings

Lighting Systems LSB-16

1BHF

PG

-ZUFTQSFBEÜ
-4#
3BEJBM
-PVWFS
-JHIU
5
1FS
'PPU
/PNJOBM
4FDUJPO

8-1/2" (21.60 cm)

1-3/4" (4.45 cm)

3

12

4

2" (5.08 cm)

3-1/2" (8.89 cm)

Half Scale

Ordering Information

Family	Lamps		Length
LSB	2
	2 = 2-Lamp T8	4	= 4-Foot
		8	= 8-Foot

Complete ordering instructions below.

Shielding		Ballast	Voltage	Finish
D
D = Radial Louver	32	= 32W T8	1 = 120 volt	AL = Aluminum
	3E	= 32W T8 Emergency Pack	2 = 277 volt	WH = White
	3D = 32W T8 Dimming

Features

1.Housing: Extruded aluminum. Die-cast end cap mechanically attached with no exposed fasteners or hardware.

2.Lamping: Two T8, 32 watt fluorescent lamps per 4-foot nominal section. Provided by others.

3.Reflector: Precision die-formed semi-specular aluminum.

4.Radial Louver: Precision die-formed aluminum straight blade louver, blades are 5/8” (1.59cm) high and 5/8” (1.59cm) O.C.

Electrical

Ballast is <10% THD, .98 ballast factor, pre-heat start. 18 gauge wire. Color- coded quick connectors allow ease of connection for joiner modules. Power feed is 18 gauge white SJT. For special circuiting consult factory. Factory installed ballast disconnect allows the ballast to be disconnected from and reconnected to incoming power under load without turning the entire circuit off.

Dimming: 120/277 VAC 1% dimming level, 4 wire feed required.

Emergency Battery Pack: 32 watt: 450 lumens @ 90 minutes, 4 wire feed required.

Mountings

Cable suspension (not shown) - 4-1/2" (11.43cm) diameter canopy finished white enamel, 1/16" (0.16cm) diameter stainless steel aircraft cable adjustable up to 36” (91.44cm). Dual-screw draw-tight connector to create hairline seam between joiner modules.

Finish

Powder coated baked white or aluminum finish. Custom colors available, consult factory.

Options and Accessories

Emergency circuiting; special circuiting; X, T & L joiner blocks - consult factory.

Labels

UL, cUL and I.B.E.W.

Ordering Instructions

Individual Fixtures:

1.Order number of MODULES required.

2.Order one POWER FEED END SET per MODULE.

Continuous Rows:

1.Determine run length.

2.Order the appropriate number of MODULES for the complete run.

3.Order one POWER FEED END SET per run.

4.Order one CABLE ASSEMBLY per MODULE minus one per run.

5.For runs that exceed amperage limits, order the appropriate number of CABLE/CORD ASSEMBLIES.

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:


"JSQPSU
3PBE
'BMM
3JWFS
."

t


t
'BY



We reserve the right to change details of design, materials and finish.

XXXMJHIUPMJFSDPN
½

1IJMJQT
(SPVQ
t #