Lightolier LSBW-7 manual Features, Electrical, Mountings, Finish, Labels, Ordering Instructions

Lighting Systems LSBW-7

1BHF

PG

-ZUFTQSFBEÜ
-4#
1JFSDFE
8BMM
.PVOU
-JHIU
5
1FS
'PPU
/PNJOBM
4FDUJPO

11-3/8" (28.89cm)

8-1/2" (21.59cm)

					1-3/4"
					(4.45cm)
			3-1/2" (8.89cm)		Pierce Pattern
	1	2	4	3	3/16" (0.48cm)
			5/8" (1.59cm)		3-1/16" (7.78cm)	1/16" (0.16cm)
Ordering Information
Type	Lamps	Length	Shielding	Ballast	Voltage	Finish

LSBW		3
	3 = 3-Lamp T5		4 = 4-Foot
			8 = 8-Foot

Complete ordering instructions below.

B

B = Pierced	28 = 28W T5	1 = 120 Volt	AL = Aluminum
	54 = 54W T5	2 = 277 Volt	WH = White
	5E = 54W T5 Emergency Pack
	2E = 28W T5 Emergency Pack
	5D = 54W T5 Dimming

Features

1.Housing: Extruded aluminum. Die-cast end cap mechanically attached with no exposed fasteners or hardware.

2.Lamping: Three T5, 28 or 54 watt (as specified) fluorescent lamps per 4-foot nominal section. Provided by others.

3.Reflector: Precision die-formed, semi-specular aluminum.

4.Shielding: Precision die-formed, pierced 20 gauges CRS Piercing is four rows that extend the entire length of the lamps. The pattern is 5/8” (1.59cm) x 1/16” (0.16cm) slot with a 3/16” (0.48cm) separation between rows.

Electrical

Ballast - <10% T.H.D., .98 ballast factor, pre-heat start. 18 gauge wire. Color- coded quick connectors allow ease of connection for joiner modules. For special circuiting, consult factory. Factory installed ballast disconnect allows the ballast to be disconnected from and reconnected to incoming power under load without turning the entire circuit off.

Dimming - 120/277 VAC, 1% dimming level.

Emergency Battery Pack - 28 Watt: 520 Lumens @ 90 min. 54 Watt: 700 Lumens @ 90 min. 4 wire feed required.

Mountings

Dual-screw, draw-tight connector to create hairline seam between joiner modules.

Finish

Powder coated baked white or aluminum finish.

Custom colors available, consult factory.

Labels

UL, cUL and I.B.E.W.

Ordering Instructions

Individual Fixtures:

1.Order number of MODULES required.

2.Order one END SET per MODULE.

Continuous Rows:

1.Determine run length.

2.Order the appropriate number of MODULES to complete the run.

3.Order one END SET per run.

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:


"JSQPSU
3PBE
'BMM
3JWFS
."

t


t
'BY



We reserve the right to change details of design, materials and finish.

XXXMJHIUPMJFSDPN
½

1IJMJQT
(SPVQ
t #