Lightolier PLA2G9LS26U Photometry, Ordering Information, Options/Accessories, Specifications

Section 2/Folio G50-52 Rev. A

	Paralyte 2424 PLA2G9LS26U
Page 2 of 2	2’ x 2’ Recessed Fluorescent, 3-1/8" Deep 9 Cell Parabolic Louver,
	Static and Air Return, 2 Lamp, T8 or T12

Photometry Model No. PLA2G9LS26U120SO

ITL40489

LIGHTOLIER

PLA2G9LS26U120SO

THIS REPORT IS BASED ON PUBLISHED INDUSTRY PROCEDURES • FIELD PERFORMANCE MAY VARY FROM LABORATORY PERFORMANCE.

LER = FP - 58.9			IW - 58.0 BF - 0.87
Comparative yearly lighting energy cost per 1000 lumens = $4.07
coefficients of utilization — zonal cavity method								(effective floor cavity reflectance 0.20)
	RF		20						20					20
	RC		80						50					30
	RW	70	50			30		50	30	10		50		30	10
	1	76	73			71		69	67	65		66		65	63
ratio	2	70	65			61		61	58	56		59		57	54
	3	64	58			53		55	51	47		53		49	47
cavity	4	59	51			46		49	44	41		47		43	40
	5	54	46			40		44	39	35		43		38	35
room	6	50	42			36		40	35	31		39		34	31
	7	47	38			32		36	31	28		35		31	27
	8	43	34			29		33	28	25		32		28	25
	9	40	32			26		30	26	22		30		25	22
	10	38	29			24		28	23	20		27		23	20
visual comfort probability (rated lumens per lamp 3150.)
	room size					ceiling height						ceiling height
W		L			8.5	10.0	13.0	16.0			8.5	10.0	13.0		16.0
20		20			71	66	69	79			68	63	63		76
20		30			74	70	66	68			71	67	62		61
20		40			77	73	70	68			74	70	66		63
20		60			79	75	73	71			76	72	69		66
30		20			76	70	67	76			74	68	63		74
30		30			79	73	66	65			76	71	63		60
30		40			81	75	69	66			78	73	67		62
30		60		lengthwise	82	77	72	68		crosswise	80	75	70		65
30		80			84	79	74	71			81	77	72		68
40		20			79	73	71	75			76	71	67		73
40		30			81	76	69	64			79	74	67		61
40		40		luminaries	83	78	72	65		luminaries	81	76	70		63
40		60			84	80	74	68			82	78	72		66
40		80			85	81	76	70			83	79	74		68
40		100			86	82	78	73			84	80	76		70
60		30			82	78	72	67			80	76	70		63
60		40			84	80	74	67			82	78	73		65
60		60			85	81	76	70			83	80	75		68
60		80			86	83	78	72			84	81	77		70
60		100			87	84	80	74			85	82	78		72
100		40			84	80	76	71			82	78	75		69
100		60			86	82	78	73			84	80	77		71
100		80			87	84	80	75			85	82	79		74
100		100			88	85	81	77			86	83	80		75

Ordering Information

Explanation of Catalog Number. Example: PLA2G9LS26U120SOGLR

PL		A		2		G	9				S
Paralyte		Body	Style:	Fixture	Ceiling Type:		Number of			Ballast Cover:
2424:	A= Air Handling			Width	G=Grid (lay-in T-bar)		Cells			S=Single V Reflector
3-1/8" Deep		/Static
Parabolic
								Louver Finish:
Precision
Contoured Pre-								L =	Low
anodized									Iridescence
Aluminum									Semi-specular
Louver								W =	(standard)
									White Paint

2

Lamp

Quantity

6U

Lamp/

Fixture Length:

6" U Lamp T8 or T12 (Nominal 24")

Voltage:				Options:
120 or 277			Add appropriate
			suffix to catalog
				no, ie: (GLR)
	Ballast Type:
1–2 Lamp Mag. T12		LE*		<10THD
		<20THD
1–2 Lamp Elec. T8		SO*		HI*
LOL T8 Dimming		PS*		–

*Instant Start Standard

Other dimming options. Consult factory.

Options/Accessories

Prewiring: 3/8" factory prewired cable (three no. 18 AWG leads, 6’ long).

Suffix: FF6, (Four no. 18 AWG leads, 6’ long). Suffix: FF14.

Fusing: Internal fast-blow fusing. Suffix: GLR. Internal slow-blow fusing Suffix: GMF.

Fluorescent Emergency Lighting System: Factory-installed emergency power battery pack with charger and inverter, concealed in fixture channel. Operates one fluorescent lamp at reduced light output for 90 minutes. Suffix: EM.

Radio Interference Filter: 120 or 277 volt, 50 or 60 Hz.

One per fixture. Suffix: R. One per ballast. Suffix: B.

Electrical Options: Special wiring, fusing or dimming ballasts and installed lamps are available, consult your Lightolier representative or factory.

T-Bar Spacer: If T-bar is less than 1-1/2" deep, order Catalog Number: STC. 2 each end is required.

Specifications

Performance: In an installation of 2 lamp 31W Iuminaires in a room cavity ratio of 1, with reflectance of 80% ceiling, 50% wall, 20% floor, the C.U. shall not be less than 73. To prevent glare the VCP shall not be less than 83 either lengthwise or crosswise (at 10Ofc level) and the average brightness at 65° shall not exceed 2817 candelas per square meter. To control veiling reflections, Iuminaire output in the 30°-90° zone shall not be less than 68.9%.

Specifications (continued)

Air Return: Designed to provide optimum air return. Air is returned through the lamp compartment for all ceiling systems and direct to plenum through slots in slot grid and narrow grid ceiling systems.

Materials: Chassis parts are die-formed code gauge cold rolled steel. Housing is embossed for rigidity with all edges turned up for safe handling. Louver is pre-anodized aluminum (Coilzak® or equal).

Finish: Louver–semi-specular anodized low iridescence, vertical grain reflector sheet. Cavity–white baked polyester minimum 86% refLectance. Phosphate undercoating. Chassis exterior–black baked polyester enamel.

Electrical: Thermally protected class “P” ballast C.B.M. approved, non PCB. If K.O.is within 3“ of ballast, use wire suitable for at least 90°.

Labels: I.B.E.W./UL and ULc Listed.

Job Information	Type:
Lightolier a Genlyte Thomas Company	www.lightolier.com

Technical Information: (978) 657-7600 • Fax (978) 658-0595

631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710 We reserve the right to change details of design, materials and finish.

© 2003 Genlyte Thomas Group LLC (Lightolier Division) A0902