I
/’- |
| AllACHING |
| INSTRUCTION | SHEET NO | “ |
INSTRUCTIONS FOR | IS:6497 |
| ||||
FRAMING | PROJECTOR ACCESSORY |
| ||||
|
|
| ||||
FOR USE WITH | LYTESPAN’) | TRACK SYSTEMS ONLY. | R0590 | Page 1 of 2 |
| |
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local re ulations. To assure full compliance with local codes and regulations, check with your local electrical inspector be ?ore installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
1 Turn the fixtures OFF and allow the LAMP to cool before attaching the PROJECTER ACCESSORY.
2, Remove LAM PHOLDER ASSEMBL.Y from fixture. See Fig. 1. Note. Style of Iampholder ~sseinbly will vary from fixture to fixture.
MR.16 LAMP
3.Flernove
4.Remove the INNER RING from PROJECTOR ACCESSORY by backing out the (2) LOCKING SCREWS (see Fig. 2).
5.Slip the INNER RING through the LAMP HOLDER ASSEMBLY making sure the notches in INNER RING clear the springs or inner ribs.
6.Slide the PROJECTOR ACCESSORY over the LAMP HOLDER ASSEMBLY. When properly positioned, hole in INNER RING will be aligned to accept LOCKING SCREWS.
7.Install LOCKING SCREWS
8.Replace the GLASS LAMP GUARD, install the proper wattage LAMP, and attach the LAMP ASSEMBLY with PROJECTOR ACCESSORY back on the fixture (see Fig. 3),
9.Turn the fixture ON and adjust the SHUTTER BLADES to frame object and focus the LENS for the sharpest beam.
SHUTTER
LENS
FIG. 3
LAMPHOLDER
ASSEMBLY
GIASS LAMP GUAR
FIG. 1
NOTCHES .,, ..
A
INNER RING
Da
u
& /, /“” LAMP HOLDER ASSEMBLY
~ w*.–
‘iv
“-
ACCESSORY
LENS
I
FIG. 2
WARNING: LAMP MANUFA~URERS REQUIRE THE GIASS LAMP GUARD BE IN PLACE BEFORE ENERGIZING LAMP, AND THAT GREAT CARE SHOULD BE TAKEN THAT LAMP IS FULLY COOLED BEFORE REIAMPING.
NOTE: This framing projector accessory is for use on specific Llghtolier ~R16 fixtures only. See fixture catalog for complete listing.
