Lightolier VRA2G9LP317 dimensions Options & Accessories, Specifications

SECTION 2/Folio G05-42 REV. A

	VR PARABOLIC VRA2G9LP317
Page 2 of 2	2'x2' RECESSED FLUORESCENT, 4" DEEP, 9 CELL (3x3) PARABOLIC LOUVER
	STATIC OR AIR SUPPLY/RETURN, IES RP1 FOR NORMAL VDT USE

PHOTOMETRY

	LER = FP - 33.0				WATTS - 47.0				BF - 0.90
MODEL NO. VRA2G9LP317 Comparative yearly lighting energy cost per 1000 lumens = $7.27
		coefficients of utilization — zonal cavity method									(effective floor cavity reflectance 0.20)
			RF		20						20					20
			RC		80						50					30
			RW	70	50			30		50	30	10			50	30	10
			1	71	69			67		65	63	62			62	61	60
		ratio	2	67	63			60		60	58	56			58	56	55
			3	62	58			54		55	53	50			54	51	49
		cavity	4	58	53			49		51	48	45			50	47	44
			5	55	48			44		47	43	40			45	42	40
		room	6	51	44			40		43	39	36			42	39	36
			7	47	40			36		39	35	33			38	35	32
			8	44	37			32		36	32	29			35	31	29
			9	41	33			29		32	28	25			31	28	25
			10	38	30			26		29	25	23			29	25	23
		visual comfort probability					(rated lumens per lamp 3150.)
			room size					ceiling height						ceiling height
		W		L			8.5	10.0	13.0	16.0			8.5	10.0	13.0		16.0
	20			20			90	89	84	81			98	97	97		93
	20			30			90	91	87	82			98	98	97		94
	20			40			91	91	89	85			98	98	97		95
		20		60			91	90	90	86			98	98	97		95
	30			20			90	89	88	84			98	98	97		93
	30			30			91	90	89	85			98	98	97		94
	30			40			91	90	91	87			98	97	98		94
	30			60			91	91	91	88			99	97	98		94
		30		80		lengthwise	91	91	90	88		crosswise	99	97	98		94
	40			40			91	91	91	88			99	97	98		94
	40			20			91	89	88	85			98	98	97		93
	40			30		luminaries	91	90	90	86		luminaries	98	97	98		94
	40			60			91	91	91	88			99	97	97		95
	40			80			91	91	91	88			99	97	97		95
		40		100			91	91	91	88			99	98	97		95
	60			30			91	91	90	86			99	97	98		94
	60			40			91	91	90	88			99	97	97		95
	60			60			91	91	91	88			99	98	97		95
	60			80			91	91	91	88			99	98	98		94
		60		100			91	91	91	88			99	98	98		94
	100			40			91	91	91	88			99	97	97		95
	100			60			91	91	91	88			99	98	98		94
	100			80			91	91	91	88			99	98	98		94
		100		100			91	91	91	88			99	98	98		95

ORDERING INFORMATION

Explanation of Catalog Number. Example: VRA2G9LP317120SOGLR

VR 2 9 P

3 17

	BODY STYLE:		CEILING TYPE:		LOUVER
	A=Air Handling		G= Grid		FINISH*:
	S=Static		(lay-in T bar)		L=Low
VR:		FIXTURE	F=Flanged	NUMBER OF	Iridescence	DUAL “V”
			(overlap)		Semi-specular
4" Deep		WIDTH	Z spline and	CELLS:	(standard)	REFLECTOR
Pre-anodized			plaster frame	(3 rows of	P=Low
Aluminum				3 cells)
			T=Slot grid or		Iridescence
Louver
			two-directional		Specular
For Normal

VDT Use	concealed T
	(see options)

LAMP

QUANTITY

LAMP TYPE/

FIXTURE

LENGTH:

17=T8, 2' Lamp

(Nominal 24")

VOLTAGE:	OPTIONS:
120 or 277	Add appropriate
	suffix to catalog
	no, ie: (GLR)
BALLAST TYPE:		<10THD
	<20THD
1&2 Lamp Elec. T8	SO*	HI*
1-3 Lamp Elec. T8	O3*	H3*
LOL T8 Dimming	PS	–
*Instant Start Standard

Other dimming options. Consult factory.

OPTIONS & ACCESSORIES

PLASTER FRAME: Catalog Number: PF22.

CONTINUOUS ROW INSTALLATION: For F type fixtures, half-width flanges are

required between fixtures. Order Catalog Number: S2FCTRIM (each joint).

SPLAY TRIM: For T ceiling type only. SUFFIX: CTZ22 S2 SPLAY TRIM.

RADIO INTERFERENCE FILTER: 120 or 277 volt, 50 or 60 Hz. One per fixture

standard. SUFFIX: RF.

ELECTRICAL WIRING OPTIONS: Consult factory.

AIR CLOSURE STRIPS: SUFFIX ACS2 (factory installed).

DRYWALL KIT: Order Catalog Number: FK92X2. (Request Folio OA30-10.)

CHICAGO PLENUM: SUFFIX: CP.

SPECIFICATIONS

PERFORMANCE: In an installation of 3 lamp 17W luminaires in a room cavity ratio of 1, reflectance 80% ceiling, 50% wall, 20% floor, the C.U. shall not be less than .69 with a spacing to mounting ratio of 1.4 perpendicular to the lamps. To meet IES RP1 preferred requirements for VDT areas the VCP (visual comfort proba- bility) shall not be less than 91 either crosswise or lengthwise and the maximum average brightness at 65°, 75° and 85° shall not exceed 238, 91 and 0 candelas per square meter respectively in the 0°, 45°, and 90° horizontal planes.

SPECIFICATIONS (continued)

AIR HANDLING: (VRA only) side air passages for air supply or air return. Optional side closure strips. Air return is also provided through the lamp com- partment through fixture body ends.

MATERIALS: Chassis parts are die-formed code gauge cold rolled steel. Housing side rails hemmed over and housing ends turned-in for safe handling. LOUVER: Pre-anodized aluminum (Coilzak® or equal).

FINISH: Chassis exterior–black baked polyester enamel. Cavity–white baked polyester enamel minimum 86% reflectance. Phosphate undercoating. Louver–low iridescence semi-specular anodized vertical grain aluminum reflec- tor sheet is standard.

ELECTRICAL: Thermally protected class “P” ballast C.B.M. approved, non PCB. If K.O. is within 3" of ballast, use wire suitable for at least 90°.

LABELS: I.B.E.W./UL and C-UL.

Job Information	Type:
Lightolier a Genlyte Thomas Company	www.lightolier.com

Technical Information: (978) 657-7600 • Fax (978) 658-0595

631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710 We reserve the right to change details of design, materials and finish.

© 2002 Genlyte Thomas Group LLC (Lightolier Division) A0902