OPERATION INSTRUCTIONS (CONT’D)
7. When toaster is not in constant use, set switch to the “STAND-BY” position.
| ! | CAUTION: When switching to this position, always come to a full stop at the “Off” position first to |
| avoid damage to the switch. |
| |
When returning to “Full” Power position for normal operation mode, allow a 5-minute warm-up period before resuming toasting operation. (If desired, return to Full power and make a slight reduction in the conveyor speed. This slower speed allows you to start toasting immediately while unit is returning to full power. After approximately 5 minutes, return conveyor speed to original setting.)
CLEANING INSTRUCTIONS
!CAUTION: Unplug toaster and allow to cool before cleaning.
The ST-1 is designed for easy cleaning. The stainless steel outer surfaces need nothing more than a daily wiping with a soft, damp cloth. The reflector tray and receiving tray should be removed daily and wiped with a soft, damp cloth to remove any crumb build-up. These components may be washed in hot sudsy water to remove any stubborn crumb build-up and should be kept clean to help promote optimum toaster performance. The conveyor belt should be cleaned with a damp cloth or a stiff bristled brush (non-metal) using a side-to-side motion.
Do not use abrasive cleaners on any part of this toaster as this will cause damage to the toaster’s finish.
Care must be taken to prevent water or cleaning compounds from getting on the internal parts, especially the switches on the control panel.
Do not immerse this toaster in water or spray water directly onto any part of this toaster as this will cause damage to the internal workings, shorten lifespan and may cause personal injury.
ST-1 Mini-Conveyor Toaster Operator Manual | 5 |
