Radio Frequency Energy, Certifications

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

￿Reorient or relocate the receiving antenna

￿Increase the separation between the equipment and receiver

￿Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

￿Consult the dealer or an experienced technician for help

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

Tested to comply with FCC

LINDY No’s 20566,

Standards.

For Home and Office use

20567, 20568

 

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - First Edition - FEB 2008

Features & Tips for Use

￿Built-in lithium battery

￿Standby time: approximately 21 days

￿Operating time: approximately 70 hours (continuous operation)

￿LED low battery indicator

￿Auto power save mode after 3 minutes of operation; click to wake up

￿To switch off the mouse, e.g. for travelling, press the mouse connection button for 5 seconds until the LED flashes once or shuts off; to wake up, press it again for 5 seconds

￿Should the mouse not connect to the RF receiver, press the connection buttons on the receiver and then on the mouse

Caractéristiques

￿Piles rechargeables au lithium

￿Durée du mode veille (standby) : environ 21 jours

￿Capacité des piles, en fonctionnement: environ 70 heures (utilisation en continu)

￿LED signalant que les piles sont vides

￿Mode d’économie d’énergie après 3 minutes de non utilisation; cliquez pour la remise en route

￿Pour éteindre la souris, pour le voyage par exemple, pressez le bouton pendant 5 secondes jusqu’à ce que la LED s’éteigne; pour la rallumer, pressez le bouton à nouveau pendant 5 secondes

￿Si la souris n’est pas reconnue au récepteur RF, pressez le bouton sur le récepteur, puis sur la souris

Eigenschaften

￿Eingebaute Lithiumbatterie, nicht austauschbar

￿Batterie-/Akkulaufzeit im Standby etwa 21 Tage

￿Batterie-/Akkulaufzeit etwa 70 Stunden kontinuierlicher Arbeit

￿LED Sensor blinkt bei niedriger Batteriespannung

￿Stromsparmodus wird automatisch aktiviert nach etwa 3 Minuten ohne Mausaktivität; Aufwecken durch Klicken

￿Zu manuellen Ausschalten der Maus, z.B. auf Reisen, drücken Sie bitte den Verbindungsschalter an der Maus für etwa 5 Sekunden bis die LED einmal kurz aufleuchtet bzw. erlischt. Um die Maus aufzuwecken drücken Sie den Verbindungsschalter ebenfalls für etwa 5 Sekunden. Sollte sich die Maus mit dem Receiver nicht spontan verbinden so drücken Sie die Verbindungsschalter am Receiver und an der Maus nochmals.

Caratteristiche

￿Batteria al litio integrata, non sostituibile

￿Periodo di Standby: 21 giorni circa

￿Durata batteria in uso continuo: 70 ore circa

￿Indicatore LED per batteria scarica

￿Modalita Auto power save dopo 3 minuti

￿Per spegnere il mouse premere il tasto di connessione sul mouse per 5 secondi fino a quando il LED lampeggia e si spegne del tutto; per riaccenderlo, premere lo stesso tasto per 5 secondi

￿Se il mouse dovesse perdere la connessione, premere nuovamente i tasti prima sul ricevitore e poi sul mouse.

Page 2
Image 2
Lindy 20566 user manual Features & Tips for Use, Caractéristiques, Eigenschaften, Caratteristiche