![](/images/new-backgrounds/1268888/2688883x1.webp)
Installation
Operating Environment
This switch must be installed and operated within the limits of the specified operating temperature and humidity (see the Specifications section)
Do not place objects on top of the unit. Do not obstruct any vents on the unit
Do not position the switch in direct exposure to the sun, or near any heat source such as a heater, radiator etc.
Prevent water and moisture entering the unit. If necessary, use a dehumidifier to reduce humidity.
Connecting Network Devices
This switch features Auto
1.Connect one end of the network cable to the
2.Follow the same procedure to connect each of the
3.The network patch cables must at least comply with the Category 5 standard for 10 and 100Mbps data transmission, and at least Category 5e for 1000Mbps transmission.
4.Please always regard that the maximum segment length of any Ethernet segment is 100m. This can be achieved by using patch cables of no more then 5m length at both ends plus an installation cable in between for the remaining length. Using higher spec network cable can increase this to a certain extent.
5.Connect the power adapter to the mains and to the power socket on the unit.
Troubleshooting
The power LED is not lit
Check the power adapter is properly connected to both the mains outlet and the switch
Make sure the power at the mains socket is switched on!
The 1000M Link LED is not lit when connected to a 1000Mbps device
Check the power cable and power switch of the device connected to the switch. Make sure it is turned on!
Check the network cable. Make sure it is properly connected to the switch and to the network device. The segment length has to be below 100 metres (see remark above) and all cables and connectors in between have to be at least category 5e compliant. (Cables which are self- made by inexperienced personnel will almost always be
Should problems persist connect a local
If you experience any other problems with the switch please contact LINDY or your supplier.
Radio Frequency Energy, Certifications
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
yReorient or relocate the receiving antenna
yIncrease the separation between the equipment and receiver
yConnect the equipment into an outlet on a circuit different from that to which the receiver is connected
yConsult the dealer or an experienced radio/TV technician for help
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
| LINDY No. 25007 |
| 1st Edition May 2005 |
Tested to Comply with FCC Standards | www.lindy.com |
For Home and Office Use |
|