HDMI Scaler/Switch | User Manual |
5.Remote Control
1.POWER:
Press the button once to power on the unit. Press again to enter standby mode.
2.INPUT:
Press the button repeatedly to toggle through the various input sources.
3.HD Input:
Press the button to directly select component input.
4.PC Input:
Press the button to directly select PC input.
5.HDMI/DVI Input:
Press the button to directly select HDMI (or DVI) input.
6.Output Resolution:
Press any one of the buttons to directly select output resolution. For other output resolutions that are not covered by these buttons please enter OSD Menu to select them.
7.MENU:
Press the button to bring up the OSD main menu page.
8.Exit:
Press the button to exit from a sub menu or main menu.
9.Up/Down/Left/Right:
Press the Up/Down button to move the highlight bar to your desired parameter during the OSD operation. Press the Left/Right button to increase/decrease the setting value of a selected parameter.
10.OK (Enter):
Press the button to confirm your selection.
11.Reset:
Press the button to reset the unit's firmware setting to the factory default value.
12.Auto Adjust:
Press the button to optimize the position of the picture (picture centering) on the screen.
6.Specifications
•Frequency bandwidth: 1.65Gbps (Single Link)
•Input Ports:
Composite & L/R audio
Component (3 RCA) & L/R audio
PC
HDMI & 3.5mm Jack (for DVI)
