Internal USB Hub
Installation and Use | English |
Benutzerhandbuch | Deutsch |
Manuel | Français |
Manuale Uso | Italiano |
|
|
LINDY Art. Nr. 32879
© LINDY ELECTRONICS LIMITED &
English Manual
Package Contents
USB hub 3.5”
USB cable (A type to 4 pin motherboard connector), fixed to 3.5” USB hub
Slot cover
4 screws
Power cable This manual
Specifications
Weight: 150g
Dimensions: 129 x 100 x 25mm / 5.07“ x 3.93“ x 1.0“
Enclosure: Synthetic
Power: DC +5V from the PC Operating temperature 0°C to 70°C
Installation
1.Select a spare 3.5“ bay and remove its front cover bezel.
2.Place the 3.5“ USB hub into the 3.5“ bay. Align the 3.5“ USB hub with the screw holes and secure the 3.5“ USB hub with two screws on each side.
3.Select a spare computer power cable connector (the same type as used for a 3.5” floppy disk drive) and insert it into the 3.5” USB hub’s power socket.
4.Route the USB cable (with A type connector) out of the computer and attach the enclosed bracket to the rear of the computer.
5.Connect the USB cable to the computer.
6.If you want to place the 3.5“ USB hub in a spare 5.25” bay, please use the 3.5” FDD to 5.25” Bay with LINDY article number 40511.
http://www.lindy.com
Deutsches Benutzerhandbuch
Packungsinhalt
USB Hub 3.5“
4 Schrauben
Stromversorgungskabel dieses Handbuch
Spezifikation
Gewicht: 150g
Abmessungen: 129 x 100 x 25mm
Gehäuse: Plastik
Stromversorgung: +5V Gleichstrom vom PC Betriebstemperatur 0°C bis 70°C
Installation
1.Wählen Sie einen freien 3.5“ Schacht und entfer- nen Sie die Frontplatte.
2.Setzen Sie den 3.5“ USB Hub in den Schacht ein, richten Sie die Bohrungen am Gehäuse des Hub aus und befestigen Sie den Hub mit 2 Schrauben je Seite.
3.Suchen Sie einen freien Stromanschluß im PC (gleicher Anschluß wie für 5.5“ Diskettenlaufwerk) und schließen Sie diesen am Hub an.
4.Führen Sie das
5.Für den Einbau in einen 5.25“ Schacht verwen- den Sie bitte den Einbaurahmen mit der LINDY Artikelnummer 40511.
http://www.lindy.com