
5. CONNECT AM-RGR TO AM/II
AM/II |
|
|
|
|
|
| |
|
|
| READER IN |
|
| ||
INDICATOR | WIRING | (GRN) | (BLK) | (WHT) | (BLU) | (ORG/YEL) |
|
VIEWING | (RED) | ||||||
STRAIN |
|
|
|
|
|
| |
WINDOW |
|
|
|
|
|
| |
RELIEF |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| AM/II |
|
|
|
|
|
|
| TERMINALS |
| PWR (RED) | GND (BLK) | DAT1 (WHT) | DATO (GRN) | DVAL (BLU) | CLK (ORG/YEL) | |
|
|
|
|
|
| ||
ROUTE WIRE THROUGH |
|
|
|
|
| TERMINALS | |
|
|
|
|
|
| ||
STRAIN RELIEF BEFORE | USE CABLE FORMULA | ||||||
WIRING TO TERMINALS | |||||||
TO DETERMINE CABLE | |||||||
(TIGHTEN LATER) | |||||||
TYPE AND MAXIMUM |
| ||||||
|
| ||||||
| LENGTH |
|
|
|
|
8. TRANSMITTER BUTTON DESIGNATIONS
REFER TO THE FOLLOWING BUTTON DESIGNATIONSWHEN SETTING THE AM/II BUTTON SCHEDULE.LEFT
RIGHT | SIGNAL, PRESS LEFT | |
BUTTON | ||
AND | ||
| ||
| BUTTONS TOGETHER. |
6. CLOSE CASE AND MOUNT UNIT
SECURE CASEWITH FOURSCREWS ANDWASHERSTIGHTENAFTERINSTALLATIONSLIDE BOARD INTO 3RD SLOT UPATTACH CASE TOMOUNTING SURFACEUSE SCREW ANCHORSOR APPROPRIATE HARDWAREFOR MOUNTING9. PROGRAM AND TEST SYSTEM
REFER TO THE AM/II PROGRAMMINGINSTRUCTIONS FOR DETAILS TOPROGRAM RECEIVERTEST TRANSMITTERS FROM VARIOUSLOCATIONS TO DETERMINE RADIO RANGEADJUST THE INTERNAL RADIO RANGEKNOB TO LIMIT RADIO RECEPTIONIF REQUIRED7. INSTALL ANTENNA
CHOOSE AN ANTENNA TO FIT THE INSTALLATION REQUIREMENTSLINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve
(12) months. The Warranty Expiration Date is labeled on the product. This warranty |
extends only to wholesale customers who buy direct from Linear or through Linear’s |
normal distribution channels. Linear does not warrant this product to consumers. |
Consumers should inquire from their selling dealer as to the nature of the dealer’s |
warranty, if any. There are no obligations or liabilities on the part of Linear |
Corporation for consequential damages arising out of or in connection with use |
or performance of this product or other indirect damages with respect to loss of |
property, revenue, or profit, or cost of removal, installation, or reinstallation. All |
implied warranties, including implied warranties for merchantability and implied |
warranties for fitness, are valid only until Warranty Expiration Date as labeled on the |
BUTTON
product. This Linear Corporation Warranty is in lieu of all other warranties express |
or implied. |
All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at
LEFT
BUTTON
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important need
BUTTON

in portable wireless signalling. However, there are some limitations which must be observed.
✶ For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part |
15 devices. As such, they have limited transmitter power and therefore limited range. |
✶ A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio |
signals that occur on or near their operating frequencies, regardless of code settings. |
✶ Changes or modifications to the device may void FCC compliance. |
NOTE: TRANSMITTER BLOOCK MUST BE PROGRAMMED INTO CONTROLLER BEFORE ACCESS CAN BE GRANTED
✶ Infrequently used radio links should be tested regularly to protect against undetected interference or |
fault. |
✶ A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale |
distributor or dealer, and these facts should be communicated to the ultimate users. |
Copyright © 2000 Linear Corporation | 217229 A |