5. CONNECT AM-RRR TO AM/II
O | 1 | O | 1 | O | 1 | B |
|
|
|
|
|
| O | 1 | B | ||||
|
|
|
|
|
|
|
AM/II |
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
| READER IN |
| |||
INDICATOR | WIRING | (GRN) | (BLK) | (WHT) | (BLU) | (ORG/YEL) | (RED) | |
VIEWING | ||||||||
STRAIN |
|
|
|
|
|
| ||
WINDOW |
|
|
|
|
|
| ||
RELIEF |
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| AM/II | |
|
|
|
|
|
|
| TERMINALS | |
|
| PWR (RED) | GND (BLK) | DAT1 (WHT) | DATO (GRN) | DVAL (BLU) | CLK (ORG/YEL) | |
|
|
|
|
|
|
| ||
ROUTE WIRE THROUGH |
|
|
|
|
| TERMINALS | ||
|
|
|
|
|
| |||
STRAIN RELIEF BEFORE | USE CABLE FORMULA | |||||||
WIRING TO TERMINALS | ||||||||
TO DETERMINE CABLE | ||||||||
(TIGHTEN LATER) |
| |||||||
| TYPE AND MAXIMUM | |||||||
|
| |||||||
|
| LENGTH |
|
|
| |||
8. PROGRAM RECEIVER
PROGRAM THE AM/II TO CONFIGURE
THE REMOTE RECEIVER
REFER TO THE AM/II
PROGRAMMING INSTRUCTIONS
FOR DETAILS
6. CLOSE CASE AND MOUNT UNIT
SECURE CASE
WITH FOUR
SCREWS AND
WASHERS
TIGHTEN
AFTER
INSTALLATION
SLIDE BOARD INTO 3RD SLOT UP
ATTACH CASE TO
MOUNTING SURFACE
USE SCREW ANCHORS
OR APPROPRIATE HARDWARE
FOR MOUNTING
9. TEST SYSTEM
TEST TRANSMITTERS FROM VARIOUS
LOCATIONS TO DETERMINE RADIO RANGE
ADJUST THE INTERNAL RADIO RANGE
KNOB TO LIMIT RADIO RECEPTION
IF REQUIRED
RECEPTION PATTERN WILL VARY
DEPENDING ON ANTENNA USED
AND SUROUNDING STRUCTURES
RADIO INDICATOR WILL
FLICKER AS SIGNAL IS
RECEIVED
STATUS INDICATOR WILL
LIGHT RED WHEN POWER
IS APPLIED AND GREEN WHEN
ACCESS IS GRANTED
7. INSTALL ANTENNA
CHOOSE AN ANTENNA TO FIT THE INSTALLATION REQUIREMENTS
MOUNTED ON POLE
DIRECTIONAL
MOUNTED ON POST
LOCAL WHIP ANTENNA (SUPPLIED)
CONNECTED DIRECTLY TO RECEIVER
SCREW CONNECTOR
ONTO RECEIVER
FOLLOW EXA ANTENNA
INSTRUCTIONS WHEN
CONSTRUCTING ANTENNA
LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve
(12)months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear
Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied.
All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important need in portable wireless signalling. However, there are some limitations which must be observed.
✶For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As such, they have limited transmitter power and therefore limited range.
✶A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.
✶Changes or modifications to the device may void FCC compliance.
✶Infrequently used radio links should be tested regularly to protect against undetected interference or fault.
✶A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.
Copyright © 2000 Linear Corporation | 212045 B |