Linear CCM-1A installation instructions Color, Camera, Module

CCM-1A	PRODUCT DESCRIPTION	1. REMOVE THE COVER PLATE
	Linear’s Model CCM-1A (P/N ACP00904A) CCTV camera can be installed inside the
	AE-100, AE-500, AE1000Plus or AE2000Plus access control systems. The camera
	provides a video signal for viewing the area in front of the system.	REMOVE BOTH
	The camera is continuously powered by the access system. Focus has been factory
Color		COVER PLATE
	adjusted to a range of three to four feet. No adjustment is needed.	RETAINING NUTS
Camera	The AE1000Plus and AE2000Plus provide a video jack for connection to a video cable
	with a Type “BNC” connector. Up to 400 feet of 75-ohm RG-59 video cable can be used.	REMOVE THE
Module	Longer cable runs may require the use of a video amplifi er.
		COVER PLATE

NOTE: If camera is being installed on an existing installation, system power should be off prior to installing the camera.

Installation Instructions

USA & Canada (800) 421-1587 & (800) 392-0123
(760) 438-7000 - Toll Free FAX (800) 468-1340
www.linearcorp.com
2. INSTALL THE WINDOW	3. REMOVE THE LENS CAP	4. INSTALL THE CAMERA
AE-100 AE-500, AE1000Plus AND AE2000Plus ONLY		REMOVE THE LENS CAP
		FROM THE CAMERA LENS

POSITION THE
GASKET ON			ATTACH THE CAMERA
THE TWO STUDS
			USING THE TWO NUTS
		AE-100 ONLY - IF THE ORIGINAL PROTECTIVE WINDOW IS
		DAMAGED, IT MAY BE REPLACED BY PRESSING IT OUT
GASKET		FROM THE OUTSIDE IN. REMOVE THE ADHESIVE BACKING
		FROM THE NEW WINDOW (INCLUDED) AND PRESS IT INTO
		PLACE, ADHESIVE TOWARDS THE FRONT.
5. CONNECT THE CAMERA AND VIDEO CABLE	6. TEST CAMERA	LINEAR LIMITED WARRANTY
CAUTION! BE SURE THE SYSTEM POWER IS OFF	APPLY POWER TO THE ACCESS SYSTEM	This Linear product is warranted against defects in material and workmanship for twenty four
		(24) months. The Warranty Expiration Date is labeled on the product. This warranty extends
2 CONNECT VIDEO	THEN VIEW THE VIDEO MONITOR TO TEST	only to wholesale customers who buy direct from Linear or through Linear’s normal distribution
	THE VIDEO OUTPUT FROM THE CAMERA	channels. Linear does not warrant this product to consumers. Consumers should inquire from
CABLE TO VIDEO		their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or
OUTPUT CONNECTOR		liabilities on the part of Linear Corporation for consequential damages arising out of or in
		connection with use or performance of this product or other indirect damages with respect
		to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation.
		All implied warranties, including implied warranties for merchantability and implied warranties
		for fi tness, are valid only until Warranty Expiration Date as labeled on the product. This Linear
		Corporation Warranty is in lieu of all other warranties express or implied.
		All products returned for warranty service require a Return Product Authorization Number (RPA#).
		Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
		FCC NOTICE: This device complies with FCC Rules Part 15. Operation is subject to the following
1 PLUG THE CAMERA'S		two conditions: (1) This device may not cause harmful interference, and (2) This device must
		accept any interference received, including interference that may cause undesired operation.
WIRING HARNESS INTO
ACCESS SYSTEM'S
CAMERA CONNECTOR
USE CABLE TIES TO
DRESS CABLE		Copyright © 2009 Linear LLC	229332 A