Linear installation instructions DXS-32FEATURES & ACCESSORIES, Remove Battery Protection Strip

DXS-32		PRODUCT DESCRIPTION
		The DXS-32 is a battery powered stationary transmitter designed for use with Linear’s DXS and DX
		format receivers. This transmitter can be used in a variety of wireless remote control applications.
	BY	Triggering the transmitter with its built-in magnetic switch sends a digitally coded wireless signal
		to its companion receiver.
		The digital DXS code format features over a million possible codes. The DXS transmitters are
		precoded at the factory to unique codes, so no fi eld coding is required. The DXS-32 can send four
MINIATURE		different codes: alarm, restore, low battery and status.
		Receivers must be programmed to the transmitter’s code before system testing and operation.
SUPERVISED		Refer to the receiver’s instructions for details on programming.
		In a typical installation, the magnet is mounted on a door or window and the transmitter is mounted
DOOR/WINDOW
		on the frame. When the magnet moves more than 1/2” away from the transmitter, an alarm signal is
TRANSMITTER		sent. When the magnet returns next to the unit, a restore signal is sent. The magnet is adjustable
		with four height positions. A 1/4” high magnet spacer is also supplied to snap on to the base of
Installation Instructions		the magnet.
		The transmitter is powered from two 3-Volt #2032 lithium batteries with an expected battery life of
		up to 4 years. Every hour, the DXS-32 will send a status transmission to the receiver. The hourly
		signal updates the receiver to the transmitter’s condition. By monitoring status transmissions, the
		receiver can determine if a transmitter has a low battery or has been removed from the system.
		DXS format receivers can monitor status signals, DX format receivers cannot.
		Normally, the transmitter sends an exit/entry delay transmission code. Cutting an internal jumper
		selects an instant transmission code. Cutting this jumper doesn’t change the time of the actual
USA & Canada (800) 421-1587 & (800) 392-0123		transmissions, but changes the code of the signal sent so the receiver can determine the
		transmitter’s function.
(760) 438-7000 - Toll Free FAX (800) 468-1340
www.linearcorp.com
DXS-32 FEATURES & ACCESSORIES		OPENING CASE
MAGNET		REMOVE THE CASE TOP BY TWISTING A
ALIGNMENT
MARKS		SMALL FLAT BLADE SCREWDRIVER IN
TRANSMITTER
	MAGNET	THE SLOT ON EITHER END OF THE TRANSMITTER
	SIDE
	MARK
	MAGNET
	ALIGNMENT
TRANSMITTER	MARKS
SCREWS AND
DOUBLE STICK TAPE
	MAGNET CAN BE MOUNTED UP TO
	1 cm FROM LEFT SIDE OF	TWIST
	TRANSMITTER
ADJUSTABLE
MAGNET	MAGNET
	ADJUSTMENT
	TAB (EACH SIDE)
MAGNET
SCREWS AND	SQUEEZE MAGNET TABS TO
DOUBLE STICK TAPE	ADJUST MAGNET HEIGHT (4 POSITIONS)
REMOVE BATTERY PROTECTION STRIP		COMPONENT LOCATIONS

ANTENNA

TWO TYPE 2032

BATTERIES

PULL OUT & DISCARD BATTERY PROTECTION STRIP TO ACTIVATE TRANSMITTER

DELAY/INSTANT JUMPER (CUT JUMPER FOR INSTANT)