H585 INSTALLATION MANUAL
®
HORIZONTALLY OR VERTICALLY MOUNTING THE H585
H585 INSTALLATION MANUAL
®
In order to install the H585 in the H588, the H585’s Trim Brackets must first be mounted to the front of the H588 as shown.
See Figure 2.
The H585 ships ready for horizontal installation. Should you choose to mount the H585 vertically, the H588 must also be mounted vertically and the camera module must be rotated 90 degrees.
NOTE: Regardless of the H585’s orientation, always make sure the wire protruding from the rear of the camera module is located in the
Once the camera module has been repositioned, be sure to tighten the bracket screw, securing the camera in the desired position.
ADJUSTING THE VIEWING ANGLE
The camera's viewing angle may also be adjusted +/- 15 degrees by carefully twisting the Camera Bracket.
POWERING THE H585 FROM A REMOTE LOCATION
Most installations will require the H585 be powered from a remote location (i.e. the main equipment location).
Figure 2 - Mounting the H585’s Trim Brackets. Note the orientation of the Trim Bracket’s inner flanges.
Camera
Bracket
Set
Screw
Camera |
Wire |
1.Use pliers or a 7/16 wrench to loosen the Set Screw and rotate the camera.
2.Make sure the Camera Wire is located in the upper right corner when the H585 is viewed from the rear.
3.Adjust the viewing angle by carefully twisting the Camera Bracket.
Figure 3 - Whether mounted horizontally or vertically, the Camera Wire should always protrude from the UPPER-RIGHT corner when the H585 is viewed from the rear.
BRAND X
ELECTRONIC DOOR LATCH MECHANISM
DOORBELL
BUTTON
(INCLUDED)
To accomplish this, remove the power connector from the power supply (included) and the H585 as shown to the
An
(Remove)
BLACK = ( - )
18/2 (for Power)
RED = (+)
12VDC
800mA
To | WHITE STRIPE |
Video Modulator | is POSITIVE (+) |
Figure 4 - Extending the H585’s power supply cable using 18/2.
Figure 5 - Connecting the H585 to an H560 amplifier. NOTE: 22 or 24 AWG 4 twisted pair wire with shield is
utilized so the color codes are not called out. Be sure to wire carefully as shown!
Page 2 | © 2004 Linear LLC. All Rights Reserved. 08/04 |
© 2004 Linear LLC. All Rights Reserved. 08/04 | Page 3 |
