1. FRONT PANEL FEATURES
TROUBLE INDICATOR | EMERGENCY BUTTON |
• NORMALLY OFF | • PRESS AND HOLD TO TRIGGER |
• LIGHTS WHEN ANY TRANSMITTERS ARE MISSING | THE EMEREGNCY ZONE |
(SUPERVISORY) | • PRESS DURING RING FOR |
• BLINKS SLOWLY WHEN ANY TRANSMITTERS | SPEAKERPHONE MODE |
HAVE A LOW BATTERY | • PRESS DURING SPEAKERPHONE |
| MODE TO DISCONNECT |
2. REMOVING BOTTOM COVER
TO ACCESS THE INSIDE OF THE CONSOLE PRESS THE TWO LOCKING TABS IN AND REMOVE THE CONSOLE'S BOTTOM COVER
POWER INDICATOR
•LIGHTS WHEN AC IS PRESENT
•BLINKS SLOWLY WHEN BATTERY IS CHARGING
•BLINKS QUICKLY WHEN AC IS ABSENT
(CONSOLE ON BATTERY POWER)
• OFF IN TEST AND SETUP MODES
CLEAR BUTTON
• STOPS ALARM
•ADDS CANCEL TO AN ALARM REPORT IN PROGRESS
•PRESS IMMEDIATELY AFTER EMERGENCY TO PREVENT REPORT
•CLEARS INDICATORS
•STOPS TROUBLE BEEPER
• PRESS FOR 5 SECONDS TO ADD A TRANSMITTER
REMOVE
COVER
PRESS
TABS
IN
|
| HOME BUTTON |
|
| |
|
| • PRESS TO RESET ACTIVITY TIMER |
| • PRESS FOR 5 SECONDS TO TURN ACTIVITY TIMER OFF | |
HOME INDICATOR |
| • IF ACTIVITY TIMER IS OFF, PRESS FOR |
5 SECONDS TO TURN ACTIVITY TIMER ON |
•LIGHTS WHEN ACTIVITY TIMER IS ON
•BLINKS SLOWLY WHEN LESS THAN 15 MINUTES REMAIN ON THE ACTIVITY TIMER
•BLINKS QUICKLY WHEN THE ACTIVITY TIMER HAS EXPIRED
SENDING INDICATOR | HOME BUTTON COVER | |
• ADHESIVE BACKED PLATE TO | ||
• NORMALLY OFF | HIDE THE HOME BUTTON IF THE | |
• FLASHES WHEN CONSOLE IS PLACING A CALL | ||
ACTIVITY TIMER IS NOT USED | ||
|
3. CONSOLE BOTTOM FEATURES
4. OPTIONAL VB-4B VOICE BOARD INSTALLATION
1 | 2 |
| ROUND MOUNTING HOLE |
16 VAC 1.25 AMP
TRANSFORMER
EXTERNAL SPEAKER, RELAY OUTPUT, AND DIALER POWER TERMINALS
BACKUP BATTERY
OPTIONAL
CONNECT BLACK
MICROPHONE WIRE
TO CENTER
TERMINAL
CONNECT RED
MICROPHONE WIRE
TO THIS TERMINAL
3 | 4 |
1 AMP 2AG
BATTERY FUSE
(HIDDEN)
LOCAL
PHONE
JACK
SEAT
MICROPHONE
5
NOTE: POWER MUST
BE OFF AND BATTERY
SHOULD BE REMOVED
CAREFULLY ALIGN PINS TO CONNECTORS ON BOTH ENDS OF BOARD
BE SURE THAT THE WHITE ARROWS ON AUDIO BOARD POINT TOWARD THE BATTERY AREA
PRESS BOARD
TELEPHONE | POWER | TEST |
LINE JACK | SWITCH | BUTTON |
OR DISCONNECTED BEFORE INSTALLING THE AUDIO BOARD
COMPLETELY
INTO CONNECTORS
NOTE: AFTER THE AUDIO BOARD IS INSTALLED AND ENABLED, THE CONSOLE WILL SPEAK INSTEAD OF BEEP DURING PROGRAMMING
1