|
| DESCRIPTION The | Coding switches are not required or used in the |
SX | photoelectric smoke alarm with a | Each transmitter is | |
SUPERVISED | FORMAT! | With the SX format, there are more than sixteen million codes | |
| to monitor alarms, restorals, low battery, status, tamper, and | possible. | |
DIGITAL SMOKE |
| test conditions. The | The smoke alarm and transmitter are powered by two |
| with any Linear SX format supervised security receiver. | ||
| batteries. These batteries are supplied with the transmitter | ||
ALARM |
|
| |
| The | and can power the unit for up to two years. If the battery | |
|
| detected. Twenty seconds after the local alarm sounds, the | voltage drops below a preset level, a low battery report is sent |
Installation Instructions |
| to the receiver with any status, alarm, tamper or test | |
| supervised receiver. The alarm signal will be repeated every | transmission. | |
|
| ||
|
| 20 seconds as long as smoke is still present. A restoral report | NOTE: After replacing batteries, press transmitter test button |
|
| will be sent when the smoke detection chamber clears. | |
|
| to reset “low battery circuit”. | |
|
|
|
(760)
Supervisory status reports are sent from the
USA & Canada (800)
Toll Free FAX (800)
www.linearcorp.com
STEP 1 Remove mounting plate. Remove the | STEP 2 Identify components. Examine the | STEP 3 Install batteries. Connect the two | ||
mounting plate by turning the plate counterclockwise. | identify the component locations. |
| and place them into battery holding cups. | |
TWIST MOUNTING | REMOVE |
| TRANSMIT LED |
|
PLATE TO | TRANSMITTER |
|
| |
MOUNTING |
|
| ||
UNLOCK |
|
| ||
BOARD | TRANSMITTER |
| ||
PLATE |
| |||
|
| |||
|
|
| ||
|
|
| TEST BUTTON |
|
|
|
|
| CONNECT AND |
|
|
|
| INSTALL TWO |
|
| BATTERY |
| |
|
|
| MN1604 ALKALINE | |
|
| COMPARTMENTS |
| OR TWO ULTRALIFE U9VL |
|
|
|
| LITHIUM BATTERIES (BOTH |
|
|
|
| MUST BE THE SAME TYPE) |
STEP 4 Pick smoke alarm location. Referring to the | STEP 5 Install mounting plate. Use the two screws and | STEP 6 Program | ||
NFPA standard on the back of this sheet, select a good | anchors provided to attach the mounting plate to the wall or | the receiver’s instructions to set it in a program or learn mode. | ||
location to mount the | ceiling. Alternately, the mounting plate can be attached to a | Press the | ||
plastic | alarm’s test button) to send a test signal. The transmit LED | |||
box is not recommended because the radio range will be | observe the “best signal” label on the bottom of the unit. | should light. Verify that the signal was received and that the | ||
reduced. |
|
|
| transmitter was properly entered into the receiver’s memory. |
|
| SCREW |
| PRESS TEST |
|
| ANCHORS |
| |
DINING KITCHEN BEDROOM BEDROOM | FOR WALLBOARD |
| BUTTON | |
|
| |||
| SMOKE | OR |
|
|
| ALARM | PLASTIC |
| |
LIVING |
|
| ||
BEDROOM |
| ELECTRICAL |
| |
ROOM |
| BOX |
| |
|
|
| ||
|
|
|
|