VB-4

AUDIO

MODULE

For Use With

PERS-2400

Personal Emergency

Reporting System

Installation

Instructions

(760) 438-7000 FAX (760) 438-7043

USA & Canada (800) 421-1587 & (800) 392-0123

Toll Free FAX (800) 468-1340

www.linearcorp.com

2. CONNECT MICROPHONE

CONNECT BLACK

MICROPHONE WIRE TO

CENTER TERMINAL

CONNECT RED MICROPHONE

WIRE TO THIS TERMINAL

5. REMOTE SPEAKER & MICROPHONE

PRODUCT DESCRIPTION

The VB-4 Audio Module is designed as an add-on accessory for the PERS-2400 Personal Emergency Reporting System Consoles. The module plugs directly into the Console’s circuit board connectors.

A digitally synthesized human voice produced by the VB-4 module announces important system information through the Console’s speaker. The volume control adjusts the voice level.

The VB-4 features 2-way audio (manual and full duplex) and audio listen-only capabilities for Central Station monitoring. The small microphone supplied fits into the Console’s case. The module’s high-gain amplifier allows the Central Station to monitor the sounds in the installation after an alarm. In 2-way full duplex mode, the Central Station operator can talk back to the subscriber through the Console’s speaker. In 2-way manual mode the Central Station operator can control the direction of the 2-way communications using a pushbutton telephone.

The Model RSM-1 Remote Speaker/Microphone can also be used with the VB-4 to increase its audio coverage area.

3. MOUNT MICROPHONE IN CONSOLE

1

PRESS FIT MICROPHONE

INTO ROUND MOUNTING

HOLE IN PERS-2400

CONSOLE CASE

2

SEAT MICROPHONE

COMPLETELY INTO

PERS-2400 CONSOLE

CASE

6. CENTRAL STATION AUDIO

1. COMPONENT LOCATIONS

MICROPHONE

EXTERNAL MICROPHONE (+)

MODULE-TO-CONSOLE

TERMINALS

 

MICROPHONE COMMON (-)

CONNECTOR

 

 

 

 

CONSOLE MICROPHONE (+)

 

 

 

2-WAY AUDIO

 

 

CONSOLE SPEAKER

 

 

VOLUME CONTROL

 

DIGITAL VOICE

(FULL DUPLEX MODE ONLY)

 

 

MODULE-TO-CONSOLE

VOLUME CONTROL

NOTE: IN 2-WAY MANUAL MODE

 

CONNECTOR

 

THE AUDIO LEVEL IS ALWAYS

 

 

AT FULL VOLUME

MICROPHONE

4. PLUG MODULE INTO CONSOLE

NOTE: POWER MUST

BE OFF AND BATTERY

SHOULD BE REMOVED

OR DISCONNECTED

BEFORE INSTALLING

THE AUDIO BOARD

CAREFULLY ALIGN

1PINS TO CONNECTORS ON BOTH ENDS OF BOARD

2 BE SURE THAT THE WHITE ARROWS ON AUDIO BOARD POINT TOWARDS THE BATTERY AREA

3 PRESS BOARD COMPLETELY INTO CONNECTORS

VB-4

VOICE

BOARD

 

 

REMOVE

 

VB-4 TERMINAL BLOCK

 

JUMPER

 

 

WIRE

 

EXTERNAL MICROPHONE (+)

5

 

MICROPHONE COMMON (-)

 

PERS-2400 CONSOLE

 

4

CONSOLE MICROPHONE (+)

 

TERMINAL BLOCK

 

3

 

 

 

 

 

USE TWISTED

 

2 - EXTERNAL SPEAKER

PAIR WIRE

 

1 - EXTERNAL SPEAKER

FOR

NOTE: REMOVE

 

 

MICROPHONE

 

 

JUMPER WHEN

 

 

 

 

 

 

USING AN

 

 

 

EXTERNAL SPKR

 

 

PROGRAM THE CONSOLE FOR THE DESIRED AUDIO MODE

CENTRAL STATION OPERATOR:

USE THESE KEYS ON A TELEPHONE SET

CONNECTED TO THE COMMUNICATOR LINE

TO CONTROL THE AUDIO MODULE

ALL

AUDIOPRESS "9" TO DISCONNECT THE CALL MODES

PRESS "3" TO LISTEN

2-WAY MANUAL

AUDIO MODE

PRESS "1" TO TALK

SPKR

 

 

SPKR

 

 

MIC (-)

 

 

MIC (+)

 

RSM-1

 

 

RSM-1 TERMINAL BLOCK

LINEAR MODEL RSM-1

TERMINALS

 

 

AFTER THE ALARM REPORT

THE "1" AND "3" KEYS ARE NOT USED IN LISTEN-ONLY AUDIO MODE

THE "1" AND "3" KEYS CAN BE USED IN FULL DUPLEX MODE,

IS SENT, THE CONSOLE WILL

SWITCH TO THE PROGRAMMED

ALTHOUGH THE MODULE WILL SWITCH TO 2-WAY MANUAL

AUDIO MODE FOR 90 SECONDS

MODE UNTIL THE NEXT CALL

 

PRESSING ANY OTHER KEY WILL EXTEND THE AUDIO TIME 90 SECONDS

LINEAR LIMITED WARRANTY

This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any.There are no obligations or liabilities on the part of Linear corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This Linear

Corporation Warranty is in lieu of all other warranties express or implied.

SERVICE INFORMATION

All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Service at 1-800-421-1587 for an RPA# and other important details.

IMPORTANT !!!

Linear radio controls provide a reliable communications link and fill an important need in portable wireless signalling. However, there are some limitations which must be observed.

For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As such, they have limited transmitter power and therefore limited range.

A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.

Changes or modifications to the device may void FCC compliance.

Infrequently used radio links should be tested regularly to protect against undetected interference or fault.

A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.

Copyright © 1999 Linear Corporation

214634 A

Page 1
Image 1
Linear VB-4 installation instructions Linear Limited Warranty, Service Information

VB-4 specifications

The Linear VB-4 is an innovative platform that exemplifies the fusion of advanced technologies and user-centric design, catering to a wide range of applications in both commercial and industrial sectors. This versatile piece of equipment has gained attention for its exceptional features, reliability, and efficiency, making it a valuable addition to any operational environment.

One of the standout characteristics of the Linear VB-4 is its robust construction, designed to withstand the rigors of demanding work environments. Its durable materials ensure longevity and reduced maintenance costs, allowing users to maximize productivity without frequent interruptions. Additionally, the VB-4 is engineered with precision, ensuring that every component functions optimally under various conditions.

The VB-4 employs cutting-edge technologies that enhance its usability and versatility. One of the key features is its intuitive user interface, which simplifies operation and allows even those with minimal training to utilize the equipment effectively. This user-friendly design minimizes the learning curve and maximizes efficiency, as users can quickly adapt to the system and begin their tasks with minimal delay.

Another notable aspect of the Linear VB-4 is its energy efficiency. With rising concerns about environmental impacts, this platform is designed to consume less power while maintaining high performance levels. This commitment to sustainability resonates well with modern enterprises aiming to reduce their carbon footprint and operational costs.

Furthermore, the Linear VB-4 boasts advanced connectivity options, enabling seamless integration with existing systems and IoT capabilities. This feature allows for real-time monitoring and data analysis, empowering operators to make informed decisions based on accurate and up-to-date information. As industries move toward data-driven operations, the VB-4 positions itself as a forward-thinking solution aligned with these trends.

In terms of versatility, the Linear VB-4 can be customized to meet specific needs, whether in manufacturing, logistics, or other sectors. Its modular design supports a range of accessories and attachments, allowing users to tailor the platform for various tasks, enhancing its overall functionality.

In conclusion, the Linear VB-4 stands out as a versatile and technologically advanced platform that combines durability, user-friendliness, energy efficiency, and connectivity. These features make it a compelling choice for businesses looking to enhance productivity while reducing their environmental impact. As industries evolve, the VB-4 is poised to remain at the forefront, delivering reliable solutions that meet the demands of today's operational environments.