WT00Z-1
Radio Frequency (RF) Controlled, 120 VAC, Wall Mounted Transmitter, Series 300
NEUTRAL | WHITE | |
120 VAC |
| BLACK |
LINE
TO MOUNT MORE THAN ONE
PUSH TOP OR
BOTTOM OF PADDLE
SWITCH ONCE TO
INCLUDE IN NETWORK
PUSH ON (PUSH
& HOLD TO BRIGHTEN)
PUSH OFF
(PUSH AND
HOLD TO DIM) GREEN GROUND
STATUS LED
SUPPLIED WITH DECORATIVE SWITCH PLATE
NOTE: This module must be “included in the Network” only where it will be permanently installed. The proper operation of this node in the mesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” confi gure this module.
|
| INCLUDING |
Linear’s family of
The
Linear
INSTALLATION
DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended for installation in accordance with the National Electric code and local regulations in the United States, or the Canadian Electrical Code and local regulations in Canada. It is recommended that a qualifi ed electrician perform this installation. Retain instructions for future use. With power off, wire this
STEP 1. Prepare the Controller to include a unit to the network by adding it to a group (method of adding a node to the network). Refer to controller instructions.
STEP 2. The
STEP 3. You should see an indication on your Controller that the “device was included” in the network.
NOTE: If you have trouble adding the
1