M a k i n g C o n n e c t i v i t y E a s i e r ™
Instant Ethernet®
Combo Ethernet LAN Card
Model No.: EC2T (w/ hourglass coupler)
After physically installing the Ethernet LAN Card in your com- puter, follow these instructions to install the network driver.
1.Start your computer and boot up Windows 2000.
Windows 2000 will automatically configure the Ethernet LAN Card Driver for your PC using the
When the Windows Desktop is displayed, you can now check to make sure that the driver is properly installed.
2.Click on the Start button, then Settings, then Control Panel.
3.When you are in the Control Panel,
4.When the System Properties box is displayed, click on the Hardware tab.
Quick Installation
For Windows 2000
This sheet will guide you through the basic steps needed to install this Linksys product on your computer. If you have any problems during installation, visit our Windows 2000 support page at www.Linksys.com.
5. In the Hardware tab, click on the Device Manager button.
6.In the Device Manager window, click the “+” next to the Network Adapters listing.
7.After you confirm that Linksys Combo PCMCIA Ethernet Card is listed, close the window.
Installation is complete.If you want to share files or printers,
refer to the Windows 2000 manual or visit our Windows 2000 support page at: www.Linksys.com
Note: Do not click Cancel or Skip at any time during the installation process. Doing so will prevent your driver from being properly installed on your PC.
