RRCCUU//IIRR SSOOCCKKEETT
Define the use of the socket marked RCU on the back panel.
Options: RRCCUU** (KNEKT Room Control Unit), IIRR(Infrared Repeater)
Default setting: RRCCUU
* For use with Linn KNEKT systems only.
PPRROODDUUCCTT IIRR
Enable or disable the infrared receiver on the front of the unit.
Options: EENNAABBLLEEDD,, DDIISSAABBLLEEDD
Default setting: EENNAABBLLEEDD
RRSS223322 SSEETTUUPP
Accesses the RS232 SETUP sub-menu.
The RS232 Setup sub-menu is for use if the AKURATE KONTROL is
communicating with other RS232 enabled products (e.g. a third-party
controller).
BBAAUUDD RRAATTEE
Set the baud rate to suit the RS232 protocol being used.
Range: 44880000 ttoo 223300440000(9 settings)
Default setting: 99660000
PPAARRIITTYY
Set parity to suit the RS232 protocol being used.
Options: EEVVEENN,, OODDDD,, NNOONNEE
Default setting: EEVVEENN
DDAATTAA BBIITTSS
Set the data bits to suit the RS232 protocol being used.
Options: 77,, 88
Default setting: 77
SSEELLEECCTTIIOONN TTIIMMEEOOUUTT
Set the time the AKURATE KONTROL takes to select a source when
the source is changed.
Range: 11 SSEECC.. ttoo 1100 SSEECC..
Default setting: 22 SSEECC..
SSTTAARRTTUUPP SSOOUURRCCEE
Set the source the AKURATE KONTROL selects when brought out of
standby.
Options: LLAASSTT UUSSEEDD,, NNOONNEE,, ((aannyy ooff tthhee ssoouurrccee iinnppuuttss))
Default setting: LLAASSTT UUSSEEDD
SSTTAANNDDBBYY RREECCOORRDD FFRROOMM
You can record from a source component to a recording device
through the AKURATE KONTROL, even if the AKURATE KONTROL is
in standby mode.* Set which source you want the AKURATE
KONTROL to select when it is in standby.
Options: LLAASSTT UUSSEEDD,, NNOONNEE,, ((aannyy ooff tthhee ssoouurrcceess)),, KKNNEEKKTT****
Default setting: LLAASSTT UUSSEEDD
* For information on setting-up a record path see Record function,
page 23.
** Is only available when KNEKT (see below) is set to LOCAL ROOM.
KKNNEEKKTT
If your AKURATE KONTROL is installed in a Linn KNEKT multi-room
system, select the appropriate setting. If your AKURATE KONTROL is
not installed in a KNEKT system, select NNOONNEE.
Options: NNOONNEE,, MMAAIINN RROOOOMM,, LLOOCCAALL RROOOOMM,, IINNTTEERRSSEEKKTT
Default setting: NNOONNEE
ENGLISH
12 AKURATE KONTROL
AKURATE KONTROL pre-amplifier - english 15/5/07 15:17 Page 20