SET-UP INSTRUCTIONS (continued)
LITTLE
WONDER BLOWER
7.Route the deflector cable above the axle and in front of the lower handle cross bar. Remove one of the nuts and the boot from the end of the deflector cable and install the cable through the key slot into the bracket on the upper handle. Reconnect the clevis from the control lever and install over the end of the cable. Reconnect the clevis to the control lever with a ¼ x 5/8 clevis pin and hairpin cotter. (Note: The deflector can be moved and held in place with the locking knob to help connect the clevis fitting to the control lever. Move the control lever to the rear to more easily connect the cable.
Loosen the knob so the deflector moves freely after the clevis is connected. (Figure 3)
8.Move the deflector control lever to the rear of the
| slot. Adjust the jam nuts on the cable fitting so | FIGURE 3 |
| the deflector is completely closed. Lock the nuts |
|
| against the bracket when the adjustment is correct. |
|
9. Secure the throttle and deflector cables to the |
| |
| handle tubes with cable ties from the hardware |
|
| package. Trim off excess. (Figure 4) |
|
10. | Fill the engine with oil to the level indicated |
|
| on the dipstick. Fill the fuel tank with clean, fresh |
|
| regular grade unleaded gasoline. |
|
FIGURE 4
10
