Little Wonder 9502-00-01 technical manual Blower Assembly Instructions, Sho Blower, See Figure

ASSEMBLY

SHO

BLOWER

Blower Assembly Instructions

NOTE : Refer to parts lists, and illustrations on Pages 14-17.

1.Install lower handles 15 on top of deck 17 & 18. Secure with (4) cap screws 5/16-18 X 1-3/4 19,

(4)5/16 flat washers 16, and (4) 5/16-18 nylon nuts 1, finger tight. (See Figure 2)

2.Install upper handle 6 with (4) 5/16-18 X 1-3/4 cap screws 19, (8) 5/16 washers 16, and (4) 5/16-18 nylon nuts 1, finger tight. Tighten lower handle nuts and bolts. Tighten upper handle nuts and bolts until the lower handle tubing pinches the upper handle. It will be normal for the lower handle tubing to crush slightly. (See Figure 2)

3.Attach brace 23 with (2) 5/16-18x2 cap screws 9,

(4)5/16 washers 16, and (2) 5/16-18 nylon nuts

1. (See Figure 2)

4.Attach throttle cable 5 to upper handle 6 with

(1)1/4-20 X 1-3/4” cap screw 8 and (1) 1/4-20

locknut 10 through hole on upper handle 6 on the left handside. Connect throttle clip 4 to upper handle (See Figure 2)

NOTE: Over tightening the screw on the left hand mounted controls could cause damage to the control.)

5.Tilt blower back on handle and install front wheel bracket 17 over the three studs on lower front of blower housing 2. Secure with (3) 5/16-18 flange nuts 1. (See Figure 3)

6.Insert pneumatic wheel sleeve 19 in front pneumatic wheel 18. Install pneumatic wheel spacers 20 over the axle sleeve on both sides of wheel and install in front wheel bracket 17.

Insert 3/8-16 X 5-1/2 axle bolt 16 through wheel bracket and axle sleeve. Secure with 3/8-16 axle nut 15. (See Figure 3)

ALL LITTLE WONDER BLOWER ENGINES ARE SHIPPED WITHOUT OIL. WHEN FILLING WITH OIL, USE SAE 30. REFER TO ENGINE MANUFACTURES INSTRUCTION MANUAL FOR PROPER ENGINE OPERATION INSTRUCTIONS.

8