Lochinvar Commercial Electric Water Heaters warranty Special Instructions To Owner, Warranty

SHP-I&S-02

INSTALLATION AND SERVICE MANUAL

COMMERCIAL ELECTRIC WATER HEATERS

52, 82, 119 Gallon, 9 kW - 54kW Input Models

FIG. 1 Front View Vertical Round Models

Installation and service must be performed by Qualified Service Personnel Only.

3.Water heater corrosion and component failure caused by air-borne chemical vapors is not covered under the manufacturer's warranty.

4.Corrosion damage caused by current leakage due to improper grounding of electrical systems or electronic components to the storage tank and related piping is not covered by the manufacturer's warranty.

5.Under no circumstance will the manufacturer be liable for consequential damages resulting from the installation or use of this equipment.

6.Correct installation procedure and local codes must be adhered to.

SPECIAL INSTRUCTIONS

TO OWNER

NOTE: Retain this manual for future reference.

This manual supplies information for the installation, operation and servicing of the appliance. It is strongly recommended that this manual be reviewed completely before proceeding with an installation.

WARRANTY WARNING:

Factory warranty (shipped with unit) does not apply to units improperly installed or improperly operated.

Experience has shown that improper installation or system design, rather than faulty equipment, is the cause of most operating problems.

1.Excessive water hardness causing a lime/scale build-up in the heater and/or on the immersion heating elements is not the fault of the equipment and is not covered under the manufacturer's warranty. (See Water Treatment and Water Chemistry)

2.Do not energize electrical system before the heater is completely filled with water. Damage caused to the immersion heating elements by dry fire is not covered under the manufacturer's warranty. Follow start up procedure in the manual.

IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency or the electric utility.

CHECKING EQUIPMENT

Upon receiving equipment, check for signs of shipping damage. Pay particular attention to parts accompanying the water heater, which may show signs of being hit or otherwise being mishandled. Verify total number of pieces shown on packing slip with those actually received. In case there is damage or a shortage, immediately notify carrier.

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. THE POSSIBLE DAMAGE TO A FLOODED APPLIANCE CAN BE EXTENSIVE AND PRESENT NUMEROUS SAFETY HAZARDS. ANY APPLIANCE THAT HAS BEEN UNDER WATER MUST BE REPLACED.

1