Step 2. Plug the 68-pin connector on the other end of the internal SCSI ribbon cable into the SCSI connector on the internal SCSI device, as Figure 2.9 shows.

Figure 2.9 Connecting Multiple Internal SCSI Devices

.

Step 3. If you have another internal SCSI device, connect the internal SCSI ribbon cable to it, as Figure 2.9 shows. You can connect other devices if the cable has more connectors. The Ultra320 SCSI host adapters support up to 15 SCSI devices connected to each SCSI channel.

Step 4. Be sure that termination is enabled at the end of the cable that is farthest away from the SCSI host adapter. Refer to Section 2.4, “Terminating the SCSI Bus,” on page 2-12for details on SCSI bus termination.

2-8

Detailed Host Adapter Installation

Version 2.2

Copyright © 2002–2004 by LSI Logic Corporation. All rights reserved.