DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
Multicarrier G2 Universal Module to R8r EPN
5-71High Reliability
5
Set Additional Administration
1. Type list configuration software-version long and press Enter to
compare the version number o f the DEFINITY ECS Release 8 software
program with the version numbe r (written on a label on the proces sor’s
faceplate). If the version numb ers are not the same, change the version
number on the processor lab el so that they agree.
2. Type change system-parameters customer-options and press Enter.
Use this screen to enable the Release 8 option and to assign the
customer’s other right-to-use optio ns on the G2-to-DEFINITY ECS Release
8 upgrade order. See

DEFINITY Enterprise Communications Server

Release 8 Administrator’s Guide

, for details on enabling these options.
3. Type change site-data and press Enter. Use this screen to assign
system-specific infor mation (such as building , floor, stations, and so
forth).
4. Type status system 1 and press Enter to verify the system is in the
“active/standby” mode.
5. Type save translation and pr e ss Enter. This instructs the system to write all
translation information from memory to the translation c ard.
!WARNING:

If the terminal screen displ ays “translation corruption d etected; c all

Lucent Technologies distributor immed iately”, an error was detected

in the translations.

Reconnect Cables
1. At the power distribu tion unit of the upgraded EPN, set the main circuit
brea ker to OFF.
NOTE:
Powering down an EPN without powering down the PPN will set off
alarms. However, these alarms should c lear after power is restored
to each EPN.
2. Temporarily disconnect the lig htwave transceivers and fib er optic cab les,
already labeled, from the ap propriate carriers.
3. Replace the back d oors or back p anels.
4. At the EPN cabinet, reconnect the lig htwave transceivers, fiber op tic
cables, and the c onnector cables assoc iated with the carrier b eing
replaced .
5. Install the front door on the EPN cabinet.