Lynx appendix Step, Always power down before working on any equipment, L-LSInstallation

eDART™ System User Guide

Lynx™ Mold-Closed Limit Switch L-LS

The Lynx™ L-LS Mold-Closed Limit Switch is a tie-bar or machine mountable machine cycle input module designed to be used with the eDART System™.

The L-LS switch can be used to easily get a machine trigger off of most injection molding machines by following the installation steps below.

Figure 25: Lynx™ Mold-Closed Limit Switch side view

U

Always power down before working on any equipment.

L-LS Installation

Step 1.

Switch the molding machine to Manual mode and close the mold.

Step 2.

Set the limit switch on the tie-bar as shown in figures 26 and 27.

U!

Be careful to note the position of the ejector plate, the mold, the limit switch and its cable, so the limit switch and/or its cable does not get caught as the mold opens and closes.

Appendix 32