5.Undo the four screws and remove the metal escape hatch (not needed for the rear mounting position). Keep the screws and the plate safe. Make sure that nothing accidentally falls inside the mixer. Pet rodents like nothing better than to nibble on electrical connections and build nests inside, so be warned.

6.Remove the two L-shaped brackets from the pod section by undoing the two screws on each one. Look at how they come out of the slots as the screws are removed, and then add them to the main section in the same way. Secure the brackets with the same screws.

7.Gently pick up the Pod without straining the wires, rotate it so the connections are pointing up, and place it over the brackets. Tuck the excess wire lengths gently inside the main unit. The Pod has two slots which fit over the brackets, so make sure the slots and the brackets line up.

8.Gently press the Pod down until it is flush with the mixer bottom surface. Make certain that none of the wires are pinched, then secure the Pod with the four screws shown below (saved from step 3).

9.Verify that your connections are secure.

10.This orientation is ideal for rack mounting, so you will want to add the rack ear brackets at this time. The details are described in the next section.

Manual s’Owner

Owner’s Manual

33