Console

 

30

29

 

 

Production

 

 

 

31

 

 

 

 

 

 

32

 

DJ

 

33

 

 

 

 

channel-4Prod.4

 

34

35

28

CUE

CUE

 

 

 

 

 

36

37

 

 

 

28. MIC ASSIGN

In the on position, the microphone signals are sent to the main mix bus (equally left and right), without affecting the level of your other program sources.

In the off position, the mic will not be heard.

In the spring-loaded, momentary talk position, each program channel is reduced by 14 dB, so you can easily make your exciting mellow-toned announcements. When released, the program channels return to their original volume after a short delay..

The mic output to FireWire is not affected by the position of this switch.

14

d.4 Pro DJ Production Console

Program Channel Section

29. LEVEL

This knob adjusts the gain of the input signals selected by the position of the source [30] switch. The knob ranges from off, to +12 dB of gain at maximum. Adjust this with your good eye on the program meter [39], so the level is typically bouncing between the 0 and +6 LEDs.

30. SOURCE

This switch selects one of three possible input sources for each program channel:

•FireWire: The signal coming in from your com- puter via the internal FireWire interface.

•Line/phono: The signal from a turntable or a line-level playback device coming from phono input [4]. (Depending on the setting of the rear-panel line/phono [5] switch.)

•CD: The signal from a CD or any other line-level device connected to the CD input [3].

You can have signals coming in on all three in-

puts, and quickly change between them using

this heavy duty switch. Although the d.4 Pro is a four channel mixer, this three-position

source selector for each channel allows you to select up to 12 different sources without repatching!

31. HIGH EQ

This knob gives you up to 10 dB of boost at 4 kHz and above, and turns off the signal at 4 kHz and above when the knob is turned to the kill position. At the center position U, there is no effect on the signal.

Note: When all three EQ knobs are turned to the kill position, the signal is effectively muted and no signal passes through to the output.

32. MID EQ

This knob gives you up to 10 dB of boost at 1 kHz, and turns off the signal at 1 kHz when the knob is turned to the kill position. At the center position, there is no effect on the signal.

33. LOW EQ

This knob gives you up to 10 dB of boost at 300 Hz and below, and turns off the signal at 300 Hz and below, when the knob is turned to the kill position. At the center position, there is no effect on the signal.