Mackie d.4 Pro Appendix D:, Replacement, Crossfader, Dimensions, Tools and qualifications, Procedure

Dimensions

4.62 in/

117 mm

14.77 in/	CUE	CUE	CUE	CUE
375 mm

12.36 in/

314 mm

WEIGHT

13.5 lb

6.1 kg

	Appendix D:	Owner’s
104 mm	Replacement
	Crossfader
4.09 in/		Manual
	Tools and qualifications
	The crossfader is designed to give you many years
	of use, but in the event of a problem (or many years of
	use) we have made it very easy to replace.
	To replace the crossfader, you will need a small
	phillips screwdriver, nerves of steel, grit, determination,
	and a steady hand. (This is not a good day to give up
	coffee.)
14.09 in/
358 mm	Procedure
	1. Turn off the d.4 Pro, and remove the power
	cord, and any other cords or cables connected
	to the d.4 Pro.
	2. Gently place the d.4 Pro face upwards on a
	flat, clean and dry surface, such as the kitchen
	table.
	3. Remove the crossfader knob, by gently pulling
	it upwards. Keep it safe.
	4. Take care to only remove the two outer screws
	of the crossfader.
	5. Gently lift up the crossfader assembly, just
	enough to be able to pull the connector out of
	the receptacle on the bottom of the assembly.

6.Insert the connector into the receptacle on the new crossfader assembly. (It will only fit in one way.)

7.Secure the crossfader assembly to the chassis with the two screws you lost in step 4.

8.Check that the crossfader is working normally.

9.You might have to reset the tension, as shown on page 17.

Owner’s Manual 25