Microphones

Front Panel

Power Amp Mode

 

 

 

 

 

switch set to

 

 

 

Mon 1/Mon 2

Rear Panel

pressHI-Z buttons

Adjust

Vocal

Compression

Send

 

 

Guitar Processor Return

HD1531

HD1531

(connected to INSERT)

Powered

Powered

 

Speaker

Speaker

C200 Passive Stage Monitors

(plays mon 2 output)

Keyboards

C300z Passive Stage Monitors

(plays mon 1 output)

Electronic Drum Kit

Powered Subwoofer

Powered Subwoofer

(plays right main mix)

(plays left main mix)

 

Manual Owner’s

This diagram shows microphones attached to the mic inputs of channels 1 to 4, electric guitars connected directly to ch. 5 and 6 (with hi-z switch pressed in), a guitar processor connected to ch.6 insert, a keyboard attached to channel 7's stereo inputs, and an electronic drum kit attached to channel 8. Add vocal compression as required, by tweaking the compression knobs on channels 1 to 4.

The power amp mode switch is set to play the monitor 1 mix on channel A, and monitor 2 mix on channel B. Note: Press in the front panel FX send/mon 2 send switch, or monitor 2 will not play.

Mackie HD1531 powered speakers and powered subwoofers are connected to the line-level main mix outputs, and play the stereo main mix to your audience.

C200 passive stage monitors are connected to the channel B speaker-level power output of the powered mixer. These play the stage monitor mix 2 to your performers. C300z passive stage monitors are connected to the channel A speaker-level power output, and play stage monitor mix 1.

Large Band System

Owner’s Manual

9