For the US 120 V model:

A maximum of five SRM450v2s can be connected per 15A service.

This allows each SRM450v2 to be safely operated at its maximum level.

When turning your system on, turn on the SRM450v2s last. This will stop any turn-on thumps and bangs from your source equipment being amplified.

When turning off your system, turn off the SRM450v2s first. This will prevent any turn-off thumps and bangs from your source equipment being amplified.

When setting up for a show, often you

are plugging into an AC power

distribution system you know

nothing about. You may even be faced with 2-wire outlets that are missing the

third safety ground pin. It’s a good idea to have a three-wire AC outlet tester in your toolbox so you can check the outlets yourself to make sure they are wired correctly. These testers will tell you if the polarity of the hot and neutral wires is reversed and if the safety ground is disconnected.

Don’t use an outlet if it is wired improperly! This is to protect yourself as well as your equipment.

Never remove the ground pin on the power cord of the SRM450v2 or any other component. This is very dangerous.

COMPRESSOR

EFFECTS

CD

SRM450v2: AC CONNECTIONS

13