- 5 -
You are now ready to mount the DWM PC board in the chassis.
___ | Install the |
| Do not drill out the holes in the PC board |
___ | Install U1 (the 68HC11) by carefully pressing it into place in its socket. Note that U1 has a |
| flattened corner that should match the socket. |
___ | Install U3 (the LM339) by carefully pressing it into place in its socket. Note that U3 has a notch that |
| should match the socket. |
___ | Install the ribbon cable with the red stripe connecting pin 1 of J7 to pin 1 of J7 (2 x 7 header) on |
| the front panel. |
___ | Install the ribbon cable with the red stripe connecting pin 1 of J8 to pin 1 of the LCD Module on the |
| front panel. |
VHF/UHF Remote Sensor Assembly Instructions
___ Install the resistors, R1 and 2.
___ Install the diodes, D1 and D2. Note the band polarity.