Before Putting Into Use
To Assemble Door Handle
(Door handle assembling
for MCWC16MCG & MCWC45MCG ) To save shipping space and avoid damage of
the unit during transportation, the door handle of this unit is shipped unassembled. Before putting the unit into use you are kindly asked to assemble the door handle as follows:
. Locate the door handle and 2 screws attached inside the cabinet, and prepare an appropriate screwdriver.
. With the 2 screws attached, fasten the door handle onto the frame of the door panel as illustrated. Be sure that the screws must point to the holes on the frame of the door panel when doing so.
·Before connecting the appliance to electrical power supply, leave it to stand for about 4 hours, which will reduce the possibility of malfunctions in the cooling system due to transport handling.
·Clean the appliance thoroughly, especially in the interior (See Cleaning and Maintenance).
·In case the interior accessories are not correctly placed, rearrange them as described in chapter "Description of the Appliance".
Instructions for Use
These instructions for use are intended for the user. They describe the appliance and correct operating procedures for safe use .
SAVE THESE INSTRUCTIONS:
Tips for Energy Saving
·Try not to open the door too often, especially when the weather is hot and humid. Once you open the door , close it as soon as possible. This is especially important if you have an upright model .
·Every now and then check if the appliance is sufficiently ventilated ( adequate air circulation behind the appliance ).
·Set the thermostat from higher to lower settings as soon as possible (depends on how loaded the appliance is, ambient temperatures etc.).
·If the gasket is damaged or the door seal is poor, energy consumption is substantially higher. To restore efficiency, replace the gasket.
·Always consider instructions stated in sections Positioning and Energy Saving Tips, otherwise the energy consumption is substantially higher.
2
