Trouble-Shooting Guide
. Sometimes you may come across minor problems that in most cases do not require a service call and can be easily eliminated. The problem may have resulted from improper handling and / or installation of the appliance. Please refer to the below
The Appliance Fails to Operate After Connecting to Electrical Power Supply
. Check the power cord is properly connected.
. Check the power supply in the electrical outlet. (blown fuse / circuit breaker) .
Continuous Operation of the Cooling System
. The door is frequently opened or left open for too long.
. The door is not properly closed (the door may sag, the gasket may be contaminated or damaged).
. Perhaps you may have overloaded the appliance.
. The reason may be inadequate ventilation of the compressor (assure adequate air circulation).
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the channel and through the outlet to the drain pan on the compressor, automatic defrosting of the appliance is assured.
In case the ice formation on the inner back wall is increased
Disconnect the power supply, leave the door open and defrost the ice. Never
use electric devices for defrosting and do not scrape the ice or frost layer with sharp objects.
After defrosting is complete, close the door, connect the power supply and set the temperature as desired. The cause of increased ice formation may be one of the following:
_ the door does not seal well (clean the gasket if it is contaminated, or replace it if it is damaged);
_ the door is frequently opened or left too long;
_ the content stored in the appliance was warm; _ the contents are touching the inner back
wall.
7
