OPERATION
Powering On
1.Insert one end of the 5V DC adapter into the back of the unit, plug the other end into a 120V wall outlet.
2.The display will turn on and the time will be shown. (You will still need to set the correct time)
3.To power on the unit, press and hold the POWER/FUNC button.
Setting the Time Manually
1.In standby mode, press and hold the MEM/SET button to enter the clock setting.
2.When you see the time digits flashing, press the NEXT 
button to set the
hours, and the PREVIOUS 
button to set the minutes.
3.Press the MEM/SET button to set the time and resume clock mode.
Note: There is an AM and PM indicator that will cycle every twelve hours.
Time Auto-Synchronization
Each time an iPod/iPhone is connected, the clock will automatically adjust to the time on the iPod.
Note: An iPod/iPhone can only sync time up to the nearest minute; it’s possible to have up to 59 seconds difference between the clock radio and the synced iPod/iPhone.
Setting the Alarm Time
1.In standby mode, press and hold the VOL+/ALM1 button to enter the alarm 1 setting, you will see the time digits flash.
2.Press the NEXT 
button to set the hours, and the PREVIOUS 
button to set the minutes. Press the VOL+/ALM1 button to save the time.
3.Press the 
/ 
buttons to choose the alarm source, (B:Buzzer, F: FM
Radio, I: iPhone/iPod) and then press the VOL+/ALM1 button to save your alarm settings.
4.To set the alarm 2, follow instructions 1 - 3 pressing
Note: Double click the ALM1 or ALM2 button to activate and
Snooze Button
1.When the alarm sounds, press the SNOOZE/SLEEP/LIGHT button to pause the alarm for 9 minutes.
2.Snooze will continue every nine minutes until the POWER/FUNC button is pressed to turn the alarm off.
Sleep Button
1.Press the SNOOZE/SLEEP/LIGHT under any function of play/pause/stop, and the sleep timer will be turned on.
2.Press the SLEEP button to cycle and choose the time to listen to music before it turns off.
3.The time will cycle as follows - 90min - 80 - 70 - 60 - 50 - 40 - 30 - 20 - 10 - OFF.
-5 -
