Magnavox DV225MG9 owner manual Information, Troubleshooting Guide, Dvd

Reset to the Default Setting (Except for PARENTAL Setting)

1 Press [SETUP] in the	2 Select “INITIALIZE”.	3 Select “YES”.
stop mode.
SETUP		OK
STOP	or		or
SETUP menu
SETUP	SETUP	SETUP	INITIALIZE
QUICK	QUICK	Initialize?
CUSTOM	CUSTOM	NO
INITIALIZE	INITIALIZE	YES

4To exit the menu

SETUP

OK

Presstwice. Note:

•When you do not wish to initialize, select “NO” at step 3.

INFORMATION

Troubleshooting Guide

If this unit does not perform properly when operated as instructed in this manual. Refer to the following:

	Problem			Corrective action
	No power.	• Make sure the power plug is connected to an AC outlet.
		• Make sure the power is turned on.
DVD	This unit does not respond to the	• Check if the power plug is connected to an AC outlet.
	remote control.	• Check the batteries in the remote control.
/		• Aim the remote control directly at the infrared sensor window. If necessary, remove all the obstacles between the sensor and the remote control.
		• You have to be within 23 feet (7m) of this unit.
VCR
		• Check if a cassette tape is in this unit.
		• Tune your radio to an empty AM station so that you hear a lot of static. Turn up the volume, then if you hear some signal sound from
		the radio in response to your pressing buttons on the remote control, the remote control is working.
		• Press and hold any button on remote control toward a digital camera. The remote control is working if you confirm infrared light
		through the digital camera.
	Poor picture or noise.	• Interference signal may be received. Change the position and direction of the unit.
	Cannot record a TV program.	• This unit does not have a tuner to receive TV broadcasting.
		• You must connect this unit to TV with audio/video output jacks or an external tuner to record TV programs. Refer to “Recording & One
		-touch Timer Recording (OTR)” on page 12 and “Satellite Link” on page 14.
	Timer recording is impossible.	• Make sure the timer program is set correctly.
		• Make sure TIMER REC indicator on this unit lights up. If not, press [TIMER SET].
		• Make sure the VCR clock is set correctly.
VCR	Cannot go into record mode.	• Make sure the cassette tape has a record tab. If needed, cover the hole with adhesive tape.
		• Activate this unit in VCR mode. Press [VCR	] on the remote control so that the VCR SOURCE light will illuminate.
	Playback picture is partially noisy.	• Adjust tracking control for a better picture by pressing [TRACKING L / K]] on the unit or [TRACKING K / L] on the remote control.
	Cannot view a picture but the	• Head cleaning may be necessary. Refer to “Auto Head Cleaning”.
	audio is OK.	• Make sure the VCR is not in the VCR menu mode.
	No or poor, playback picture.	• Fine tune your TV.
	Video or color fades in and out when	• You cannot copy a copyrighted cassette tape.
	making a copy of a cassette tape.
	Cannot remove the cassette tape.	• Check if this unit is in the VCR mode. If not, press [VCR		] on the remote control to switch the mode.
	No picture.	• Connect the video cable firmly.
		• Insert a correct video disc that can be played back on this unit.
		• Press [DVD ] on the remote control. Check if the DVD SOURCE light will illuminate. Then try other DVD features.
		• Set “PROGRESSIVE” correctly in “DISPLAY” menu. Turn it on only if your TV has progressive scan and you are using the component
		video connections between the unit and the TV. Disable progressive scan for all other connections. Refer to page 6.
	Disc cannot be played back.	• Insert the disc.
		• Clean the disc.
		• Place the disc correctly with the label side up.
		• Cancel the parental lock or change the control levels.
		• Handle a disc with special care so that it does not have fingerprints, scratches, or dusts on its surface.
	No sound.	• Connect the audio cables firmly.
		• Turn on the power of the audio component.
		• Correct the audio output settings.
DVD		• Correct the input settings on the audio component.
	No DTS audio is output.	• This unit does not support DTS audio.
		-This is not a malfunction.
	Distorted picture.	• Connect this unit directly to the TV.
		• There are some cases where pictures may be slightly distorted, and those are not a sign of a malfunction.
		• Although pictures may stop for a moment, this is not a malfunction. Refer to page 15.
		• Check if the progressive mode is set correctly according to your TV. Refer to pages 20-21.
	Audio or subtitle language does	• The selected language is not available for audio or subtitles on the DVD.
	not match the setting.	-This is not a malfunction.
	The camera angle cannot be	• The DVD does not contain sequences recorded from different camera angles.
	changed.	-This is not a malfunction.
	Audio or subtitle language	• The DVD does not contain audio source or subtitles in the selected language.
	cannot be changed.	-This is not a malfunction.
	“ ” appears on the TV screen,	• That operation is prohibited by this unit or the disc.
	prohibiting an operation.	-This is not a malfunction.

•Some functions are not available in specific modes, but this is not a malfunction. Read the description in this manual for details on correct operations.

•Playback from a desired track and random playback are not available during programmed playback.

•Some functions are prohibited on some discs.

– 23 –

INFORMATION

EN