23
1 
4
001985
Straight guide
1.Feed direction
2.Bit revolving direction
3.Workpiece
4.Straight guide
Templet guide (Accessory)
003262 |
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns. To install the templet guide, loosen the screws on the tool base, insert the templet guide and then tighten the screws.
1
2
3
003263
1.Screw
2.Base plate
3.Templet guide
The straight guide is effectively used for straight cuts when chamfering or grooving.
To install the straight guide, insert the guide bars into the holes in the tool base. Adjust the distance between the bit and the straight guide. At the desired distance, tighten the wing bolts to secure the straight guide in place.
| 1. Straight guide | |
| 2. | Guide bar |
| 3. | Wing bolt |
1 |
|
|
2 | 3 |
|
003260 |
|
|
When cutting, move the tool with the straight guide flush with the side of the workpiece.
If the distance (A) between the side of the workpiece and the cutting position is too wide for the straight guide, or if the side of the workpiece is not straight, the straight guide cannot be used. In this case, firmly clamp a straight board to the workpiece and use it as a guide against the router base. Feed the tool in the direction of the arrow.
A |
003261 |
Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet.
1 | 7 | 1. | Bit |
|
| 2. | Base |
2 |
| 3. | Templet |
| 4. | Workpiece | |
|
| ||
3 |
| 5. | Distance (X) |
| 6. | Outside | |
4 |
| ||
|
| diameter of the | |
5 |
|
| |
|
| templet guide | |
| 6 |
| |
| 7. | Templet guide | |
003695 |
|
|
|
NOTE: |
|
|
|
•The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - bit diameter) / 2
7
